| Author |
Message |
Luuk Uiterwijk (Luuk__annet)
Junior Member
Username: Luuk__annet
Post Number: 70
Registered: 7-2002
| | Posted on Monday, September 01, 2003 - 3:39 am: | |
Thanks for your advise I will give it a try and let you know the results.
Luuk
|
Paul Hill (348paul)
Member
Username: 348paul
Post Number: 383
Registered: 12-2002
| | Posted on Sunday, August 31, 2003 - 2:46 pm: | |
Luuk,
This should help
http://www.ferrarichat.com/discus/messages/21/202336.html?1044590086
Paul |
Ernie (Ernie)
Member
Username: Ernie
Post Number: 784
Registered: 11-2001
| | Posted on Sunday, August 31, 2003 - 1:04 pm: | |
Luuk
Have you tried to loosen the two screws that hold the shift gate down, scoot the gate back when they are loose, and then tighten it back up? The other thing it could be is, there are four small bolts under the car that hold the shifter housing in place. It could be that the two nuts on the bolts closer to the rear of the shifter are a little bit loose causing the the back part of the shift housing to hang down. Does the housing move at all? If it does I would check that. It also could be that the shift linkage needs to be adjusted. There are two cables under the car that run from the shifter housing to the gear box. At each end of the cables there are nuts that tighten and loosen the slack in the cable. One side could be a little tighter than the other causing the shifter to move more one way than the other. Good luck, hope I was able to help. |
Luuk Uiterwijk (Luuk__annet)
Junior Member
Username: Luuk__annet
Post Number: 69
Registered: 7-2002
| | Posted on Sunday, August 31, 2003 - 12:18 pm: | |
Hello,
When I put my gear into first third or fifth gear I seem to have about 10mm left until I reach the end of the shift gate however in reverse second and fourth it looks like the gear stick isn�t going far enough and it reaches the end of the shift gate plate to soon.
Is there some way to adjust this?
Any help will be much appreciated,
Luuk
|