| Author |
Message |
Ken Sullender (Sulley)
New member
Username: Sulley
Post Number: 46
Registered: 9-2003
| | Posted on Thursday, September 18, 2003 - 8:16 pm: | |
Thanks for the feedback |
stacy o'blenes (Stacy)
Junior Member
Username: Stacy
Post Number: 77
Registered: 8-2001
| | Posted on Wednesday, September 17, 2003 - 10:45 am: | |
What is the procedure to replace the engine bonnet cable. There is a little bit in the archives but it is unclear. Can you just withdraw the cable form the door jam and thread a new one in. Is the cable housing fixed in place inside the body work?
Thanks |
Malcolm West (Ferrari_uk_tech)
Junior Member
Username: Ferrari_uk_tech
Post Number: 142
Registered: 7-2003
| | Posted on Wednesday, September 17, 2003 - 10:12 am: | |
Don't wait for it to snap, first of all check to see if it is the catches that may need cleaning and lubricating, are the catches releasing together? Then remove the cable and see if its frayed or just requires lubrication. Also make sure that the emergency cable is operating correctly - the emergency pull is to be found under the small pocket to the right of the bonnet opening lever, just by your left knee.
MW |
Ken Sullender (Sulley)
New member
Username: Sulley
Post Number: 37
Registered: 9-2003
| | Posted on Wednesday, September 17, 2003 - 9:47 am: | |
My 85 QV cable for the engine bonnet is getting extremely difficult to pull open. I fear due to the force to open that I am on the verge of it snapping. Any advice? Thanks |