| Author |
Message |
manny wong (Racerx)
New member
Username: Racerx
Post Number: 3
Registered: 10-2003
| | Posted on Thursday, October 02, 2003 - 12:17 pm: | |
Thanks Steve. That's what I needed to know. This forum is great. Thanks to everyone who contributed.
Take care and have fun |
Steve Magnusson (91tr)
Intermediate Member
Username: 91tr
Post Number: 2139
Registered: 1-2001
| | Posted on Thursday, October 02, 2003 - 12:04 pm: | |
If you've got a wheel/tire assembly (or a bare wheel) to measure:
1. Place the inboard sidewall of the tire (or wheel) against a flat surface -- measure from the flat surface to the wheel mounting surface, call this "A".
2. Place the outboard sidewall of the tire (or wheel) against a flat surface -- again measure from the flat surface to the wheel mounting surface, call this "B".
3. offset = (A-B)/2 (and is "+" if A is larger than B or "-" if A is smaller than B).
|
manny wong (Racerx)
New member
Username: Racerx
Post Number: 2
Registered: 10-2003
| | Posted on Thursday, October 02, 2003 - 11:50 am: | |
Thanks guys. I seem to recall that it was a 5 x 108mm. How do I measure the offset? |
Steve Magnusson (91tr)
Intermediate Member
Username: 91tr
Post Number: 2138
Registered: 1-2001
| | Posted on Thursday, October 02, 2003 - 11:35 am: | |
(I'd be very surprised if the bolt pattern wasn't 5 x 108 mm, but) Measure the distance between any 2 non-adjacent holes (or studs) in the 5-bolt pattern -- if the distance is ~102.7 mm (~4.04") then the bolt circle is 108 mm (if it's some other distance we can math it out). |
Alan Leach (Speedy308)
Junior Member
Username: Speedy308
Post Number: 218
Registered: 12-2002
| | Posted on Thursday, October 02, 2003 - 11:17 am: | |
John at 713 682-0370 is finishing an engine install on a 246. He can possibly help you. |
Ira Schwartz (Iraschwartz)
New member
Username: Iraschwartz
Post Number: 34
Registered: 5-2003
| | Posted on Thursday, October 02, 2003 - 11:01 am: | |
Actually, the Cromodoras are 14x6.5", but I don't recall offset or bolt pattern- sorry. |
manny wong (Racerx)
New member
Username: Racerx
Post Number: 1
Registered: 10-2003
| | Posted on Thursday, October 02, 2003 - 10:15 am: | |
NE1 know the bolt pattern and wheel offset for the Dino? I only know that the wheels are either 14x7 (cromodora) or 14x7.5 (campagnolo).
Thanks |