| Author |
Message |
Mitchell Le (Yelcab1)
Member
Username: Yelcab1
Post Number: 734
Registered: 11-2001
| | Posted on Monday, October 27, 2003 - 2:21 pm: | |
You do need to take the dash apart.
The speedo is held (I use that term loosely) by a U bracket. The side-ends of the U-bracket is placed against the backside of the dash panel, and the bottom-part of the U-bracket it screwed into the back of the speedo with knurled thumbwheels.
|
Dom Vitarella (Dom)
Member
Username: Dom
Post Number: 516
Registered: 11-2002
| | Posted on Monday, October 27, 2003 - 12:45 pm: | |
Finally did a time trial with my GT4 on Friday. During one of the runs, I noticed my speedo had turned slightly. Upon further examination, it is definately loose, and if it werent for the speedo cables, I could probably turn it round and round.
How are these things attached? Do I need to take apart the dash (I hope not- It looks like there may be some access from below,)? I am hoping that it is just a screw that holds it in place that came loose.
Dom |
|