| Author |
Message |
Andrew-Phillip Goalen (Andrewg)
Member
Username: Andrewg
Post Number: 379
Registered: 9-2002
| | Posted on Wednesday, September 17, 2003 - 7:43 pm: | |
www.namrick.co.uk |
Paul Wehmer (Pwehmer)
Junior Member
Username: Pwehmer
Post Number: 211
Registered: 10-2002
| | Posted on Wednesday, September 17, 2003 - 7:38 pm: | |
I'm surprised they wouldn't make them- they've made specials for me in much smaller quan. then a 1,000.
http://www.wmberg.com/manufacturing.html
will make about anything.
Dave- the ARP place looks great- thanks.
|
Dave Burch (Merlyn)
Junior Member
Username: Merlyn
Post Number: 136
Registered: 8-2002
| | Posted on Wednesday, September 17, 2003 - 8:49 am: | |
I know ARP will make short run specials. and they are absolutly one of the best. They make lots of fasteners for F1, almost everyone in racing who is serious uses their fasteners.
http://www.arp-bolts.com/ |
ELI (Titanium360)
Member
Username: Titanium360
Post Number: 605
Registered: 4-2002
| | Posted on Wednesday, September 17, 2003 - 7:42 am: | |
David, i called them but was told that the thread pitch is too fine for them and they will not make it. |
David Feinberg (Fastradio2)
Member
Username: Fastradio2
Post Number: 354
Registered: 4-2002
| | Posted on Wednesday, September 17, 2003 - 7:39 am: | |
Eli,
When I contacted metricmcc, via phone, about some special studs that I was looked for..they told me that they will make anything to spec. Give 'em a call...
Regards,
David |
ELI (Titanium360)
Member
Username: Titanium360
Post Number: 604
Registered: 4-2002
| | Posted on Wednesday, September 17, 2003 - 6:35 am: | |
Paul, thanks so much but they did not have the 1.25 thread pitch i needed. any other recommendations? |
Paul Wehmer (Pwehmer)
Junior Member
Username: Pwehmer
Post Number: 209
Registered: 10-2002
| | Posted on Wednesday, September 17, 2003 - 4:33 am: | |
http://www.metricmcc.com/
part number W151 FL |
Mitch Alsup (Mitch_alsup)
Intermediate Member
Username: Mitch_alsup
Post Number: 1051
Registered: 4-2002
| | Posted on Tuesday, September 16, 2003 - 1:52 pm: | |
Aircraft Spruce--no really! |
ELI (Titanium360)
Member
Username: Titanium360
Post Number: 602
Registered: 4-2002
| | Posted on Tuesday, September 16, 2003 - 1:23 pm: | |
need to buy 1000 hexagon flange lock bolt screw measurements M12* 35mm 1.25 thread pitch |