Author |
Message |
David Burch (Merlyn)
New member Username: Merlyn
Post Number: 19 Registered: 8-2002
| Posted on Thursday, October 24, 2002 - 8:19 pm: | |
Cut a couple of pieces of wood that are just a bit thicker than the jacking chanels are deep,and slip them into the chanels, that way you won't bend the chanels over. |
Matt Karson (Squidracing)
Junior Member Username: Squidracing
Post Number: 200 Registered: 3-2001
| Posted on Thursday, October 24, 2002 - 2:03 pm: | |
There are 2 jacking points on each side of the 355. BretM mentioned what they look like, and they are located near the front and rear end of the rail under the rocker panel, on each side. |
BretM (Bretm)
Advanced Member Username: Bretm
Post Number: 2780 Registered: 2-2001
| Posted on Thursday, October 24, 2002 - 12:37 pm: | |
All the Ferraris usually have a jack point which is two 1/2" pieces of sheet metal hanging down like 2" apart, you can see them if you feel underneath or look. Ferrari's pretty good at making sure the cars can be jacked up properly. If for some reason these aren't there or are crushed, then you should be able to use the frame on the 355 in the back, you might want to pull of the undertray. Point of my rambling is that you'll find a good place to use. |
Martin (Miami348ts)
Advanced Member Username: Miami348ts
Post Number: 3035 Registered: 5-2001
| Posted on Thursday, October 24, 2002 - 12:22 pm: | |
ON the 348 ther eis a point in the middle between the tires. There you can lift the whole side. It is marked. on the fold. Look for it, I am sure the 355 has the same!
|
Angelo H. Oliva (Blicima_355)
New member Username: Blicima_355
Post Number: 12 Registered: 8-2002
| Posted on Thursday, October 24, 2002 - 11:20 am: | |
I need to take off my right rear tire. Any suggestions on where I put my floor jack... Thanks.... AHO |