| Author | Message | ||
| Christopher McCormick (92_348ts)
Junior Member Username: 92_348ts Post Number: 71 Registered: 6-2002 |
Martin-I am getting ready to have a pair of OEM SF shields countersunk into my 348 as well. Here are the measurements... DRIVER'S SIDE FENDER-Using the crease that runs along the fender as your guide, the upper right hand corner of the shield should be 1.5" below the crease straight below a point 4" along the crease from the door/fender joint. The left corner should be 1.75" below the crease from a point 7.5" along the crease from the door. Bear in mind that ther fender indention is slightly larger in every dimension to allow the shield to sit within it. Reverse all measurements for passenger side. Lastly, I you type "Ferrari F355 Fiorano" into any search engine it will give you hundreds of pictures of the car with it's factory recessed shields. Let me know how it turns out, Chris | ||
| ELI (Titanium360)
Junior Member Username: Titanium360 Post Number: 238 Registered: 4-2002 |
Hey Bruce, good memory! have a great holidays. | ||
| ELI (Titanium360)
Junior Member Username: Titanium360 Post Number: 237 Registered: 4-2002 |
Martin: These are the measurment i got from ACW when i put them on my 360 and found it to be exactly the same as the factory installed shields: When looking at the driver side, the top right corner of the shield is 72mm from the door (excluding door gap). The bottom edge of the shield is 84mm from the door (again, excluding door gap). Look into my profile for the pic. | ||
| TomD (Tifosi)
Intermediate Member Username: Tifosi Post Number: 2056 Registered: 9-2001 |
here it is for the 360. I am sure you could use this you owe me another miami dinner  http://www.ferrarichat.com/discus/messages/21/30950.html | ||
| bruce wellington (Bws88tr)
Intermediate Member Username: Bws88tr Post Number: 1311 Registered: 4-2002 |
yea tom, i think it was eli?? | ||
| TomD (Tifosi)
Intermediate Member Username: Tifosi Post Number: 2054 Registered: 9-2001 |
martin I remember the archives someone posted the exact location | ||
| bruce wellington (Bws88tr)
Intermediate Member Username: Bws88tr Post Number: 1310 Registered: 4-2002 |
martin ask L WAYNE he should have some... | ||
| Noelrp (Noelrp)
Junior Member Username: Noelrp Post Number: 138 Registered: 8-2001 |
Martin, How about search thru your Forza magazine collection. If I recall, there are few pix there. -n | ||
| Martin - Cavallino Motors (Miami348ts)
Advanced Member Username: Miami348ts Post Number: 3471 Registered: 5-2001 |
damn. nobody here except Jay? | ||
| J. Grande (Jay)
Member Username: Jay Post Number: 906 Registered: 10-2001 |
Martin, all the horses I have seen on "real" shields have been black. I have seen a set on ebay that are a pewter color, almost gunmetal black which look nice (and compared to the originals cheap), but not original looking. | ||
| Martin - Cavallino Motors (Miami348ts)
Advanced Member Username: Miami348ts Post Number: 3466 Registered: 5-2001 |
Who has factory installed recessed shields on his car? What color is the horse? exact location (need pictures. I am dropping of my car at the body shop to have a set of recessed shields installed into my fender. My Christmas present. ...also to get the front spoiler dre-done, my present stupidity! |