| Author |
Message |
Jeff Green (Carguy)
Member
Username: Carguy
Post Number: 390
Registered: 10-2002
| | Posted on Sunday, July 20, 2003 - 8:12 pm: | |
Yes...there was a recent problem where someone had a kock-off wheel bolt over-tightened so much that they tried many solutions, but ended up going to some big truck service place (I think?) and had them use a BIG impact wrench to loosen it. |
Taek-Ho Kwon (Stickanddice)
Intermediate Member
Username: Stickanddice
Post Number: 1673
Registered: 11-2002
| | Posted on Sunday, July 20, 2003 - 5:39 pm: | |
Do a search on this. I think Terry Springer and Jim Glickenhaus had some solutions.
Cheers |
thomas daniels (Castex)
Junior Member
Username: Castex
Post Number: 59
Registered: 6-2003
| | Posted on Sunday, July 20, 2003 - 4:21 pm: | |
You ought to have a big lead mallet in the boot somewhere, no? Or have you already tried that? |
mwg (Mwg)
New member
Username: Mwg
Post Number: 1
Registered: 7-2003
| | Posted on Sunday, July 20, 2003 - 3:37 pm: | |
Any input of how to remove a stuck spinner. I have a 3/4 inch drive tool and about a 3 to 4 foot tork bar and I can't get it to break loose!Any suggestions. |