Author |
Message |
arthur chambers (Art355)
Member Username: Art355
Post Number: 434 Registered: 6-2001
| Posted on Saturday, June 08, 2002 - 10:03 am: | |
I'm told that they are different, and that the 355 attachment change wasn't for the better. They tend to leak, while the 348 didn't. Art |
Eric Vartanian (Evartanian)
New member Username: Evartanian
Post Number: 18 Registered: 3-2002
| Posted on Friday, June 07, 2002 - 8:17 pm: | |
Actually Martin, I'm in L.A., so I can't. Asking a dealer might be interesting--last week I saw 355 GTS at Orange County so that's half the equation, I don't remember a 348 though, maybe I'll call. But, neither of the dealers seemed too encouraging to help figure the problem though, so I'm kinda hesitant about that. As I said earlier, if perhaps anyone also might know of potential sources for tops, I'd appreciate the help. |
Ric Rainbolt (Ricrain)
Junior Member Username: Ricrain
Post Number: 131 Registered: 2-2002
| Posted on Friday, June 07, 2002 - 3:45 pm: | |
Not trying to be preachy, but the 355 shares only two panels with the 348 (If I remember right, the upper door panels). While many panels are very similar, almost none are interchangeable. I know the roof seal kit from a 355 fits the 348 with slight modifications (to the 348), so there's at least a reasonable chance the tops are interchangeable. |
Frank Parker (Parkerfe)
Member Username: Parkerfe
Post Number: 935 Registered: 9-2001
| Posted on Friday, June 07, 2002 - 2:54 pm: | |
I know that most of the 348 and 355 body panels are the same. |
Martin (Miami348ts)
Intermediate Member Username: Miami348ts
Post Number: 2151 Registered: 5-2001
| Posted on Friday, June 07, 2002 - 2:47 pm: | |
was wondering the same. can you find somebody in your area to make the swap test? Maybe even a dealer? If you are close to miami comes here. I have two 348s you can try.
|
Eric Vartanian (Evartanian)
New member Username: Evartanian
Post Number: 16 Registered: 3-2002
| Posted on Thursday, June 06, 2002 - 1:22 am: | |
I'm hoping you guys can help me resolve a dilemna I'm having. I am in the market for a top for my 95 F355 GTS. An authorized dealer gave me a price of about $3k for a new one with leather lining. Before I fork out the money, I decided that if I could find a good used/salvage top at a significantly lower price I'd go for it. Recently, I found a dismantler who said he found a 355 top, but then later told me it was from a 348--and he insists that the 348 top is the same as/will fit the 355. He says that other than the liner design it is the same. I inquired a few different dealers in the area and they all say that the top is different/under a different part number and that it probably wont fit--but said though if it perhaps does, then I'm in luck. I am wondering if the 348 top is the same as or will fit a 355 perfectly? Has anyone perhaps tried this, or maybe could try it if you have both or know someone you could swap with. I would appreciate any help immensely. Or perhaps if you might know of a source where I might find a top for the F355 GTS. Thanks -Eric |