| Author | Message | ||
| Mitchell Minh Le (Yelcab1)
Member Username: Yelcab1 Post Number: 339 Registered: 11-2001 |
Problem is my #22 is stuck on there and cannot slide off. Frozen by age, or rust, or corrosion, or glue. Any thoughts? | ||
| phil hooper (Wolftalk)
New member Username: Wolftalk Post Number: 33 Registered: 5-2002 |
here ya go. the lip seal is #21. you should be able to remove the housing (#22) without removing the TO bearing fork.  | ||
| Mitchell Minh Le (Yelcab1)
Member Username: Yelcab1 Post Number: 338 Registered: 11-2001 |
Does any one have a picture of the clutch shaft to bell housing assembly that shows all the internal parts? I am looking for an oil seal that may be inside some where. |