| Author |
Message |
Verell Boaen (Verell)
Member
Username: Verell
Post Number: 337
Registered: 5-2001
| | Posted on Monday, September 16, 2002 - 12:26 am: | |
Toss the #$!@# pegs. Go to the HW store & get black allen head set screws.
All but 1 of my clips stay in place w/o the pegs. I keep forgetting to take a spare clip with me so I can size the set screws.
|
Ken Ross (Kdross)
Junior Member
Username: Kdross
Post Number: 128
Registered: 2-2002
| | Posted on Saturday, September 14, 2002 - 6:06 pm: | |
Thanks Mark. Now I just have to find the right tool to knock the crap out of those damn pegs. |
Mark Eberhardt (Me_k)
Junior Member
Username: Me_k
Post Number: 111
Registered: 5-2002
| | Posted on Saturday, September 14, 2002 - 4:59 pm: | |
They are buggers. I used a hammer and a punch. You need to hit it nice and straight and the punch needs to a flat flat that covers the whole pin. |
Ken Ross (Kdross)
Junior Member
Username: Kdross
Post Number: 127
Registered: 2-2002
| | Posted on Saturday, September 14, 2002 - 4:31 pm: | |
I just purchased about 10 black plastic clips that hold the red ignition wires to the engine block. They have a small tip that I am assuming gets pushed into the clip and engine block to firmly hold the clip in place. When I took a small screwdriver and hammer to gently pound the tip in nothing happened. I then pounded harder only to destroy the tip. How the hell do I properly pound the tip in without destorying it? |