| Author | Message | ||
| '75 308 GT4 (Peter)
Intermediate Member Username: Peter Post Number: 2038 Registered: 12-2000 |
I will  | ||
| Rob Lay (Rob328gts)
Board Administrator Username: Rob328gts Post Number: 2247 Registered: 12-2000 |
Ok, score is now... Ric 1 David 1 Everyone else 0 Who's posting the next one? | ||
| Ric Rainbolt (Ricrain)
Member Username: Ricrain Post Number: 260 Registered: 2-2002 |
David is da man. That was a really obscure part, too. I'm not sure I would have even guessed. | ||
| David Feinberg (Fastradio2)
Junior Member Username: Fastradio2 Post Number: 158 Registered: 4-2002 |
Been a long, long time since I've been in a 308/328 motor (the BB is just so demanding..). Ok, alignment dowels for sure. Perhaps between the engine and the housing the bolts the engine/transaxle together...or in that area. David | ||
| JohnR. (Rivee)
Junior Member Username: Rivee Post Number: 100 Registered: 1-2002 |
Door alignment dowels | ||
| Rob Lay (Rob328gts)
Board Administrator Username: Rob328gts Post Number: 2243 Registered: 12-2000 |
Oh oh, are those the alignment dowels for the rear bonnett? To make sure the fit is aligned correctly when closed? Wait a second, that thing is way too big for that. | ||
| Dan B. (Dan_the_man)
New member Username: Dan_the_man Post Number: 15 Registered: 9-2002 |
gearbox dentent ball sleeves | ||
| Ric Rainbolt (Ricrain)
Member Username: Ricrain Post Number: 259 Registered: 2-2002 |
David almost has it! | ||
| JohnR. (Rivee)
Junior Member Username: Rivee Post Number: 99 Registered: 1-2002 |
It's what Magoo has been saying for months. A reverse exhaust muffler spindle coupling bearing.(something like that) | ||
| Ben Lobenstein 90 TR (Benjet)
Member Username: Benjet Post Number: 792 Registered: 1-2001 |
It's a part of a hand, AGAIN! (this time prolly Ric's not Rob's) oh you meant what is the metallic item, placed upon the hand? uh, well I'm not that 3x8 knoweldgeable but I'd guess some sort of breather (or check valve), or a union between air/vacuum lines... -Ben | ||
| David Feinberg (Fastradio2)
Junior Member Username: Fastradio2 Post Number: 157 Registered: 4-2002 |
Alignment dowels...Can't remember where it goes, though. | ||
| C. Smith (Italianauto)
Junior Member Username: Italianauto Post Number: 129 Registered: 10-2001 |
Is it the breather fitting....goes into the valve covers? | ||
| Tim Hogan (Tojo)
Junior Member Username: Tojo Post Number: 60 Registered: 4-2002 |
Is it the water fitting that comes out of one of the heads or the thermostat housing? | ||
| Ric Rainbolt (Ricrain)
Member Username: Ricrain Post Number: 256 Registered: 2-2002 |
 Hints: 1) It's from a 308, but could be found on any 308 or 328. 2) There are two per car. 3) It could possibly be installed backwards, but the consequences of doing so would be minor. |