| Author |
Message |
Michael N. (Man90tr)
Member
Username: Man90tr
Post Number: 701
Registered: 4-2001
| | Posted on Sunday, October 20, 2002 - 8:14 pm: | |
Thanks Tom. |
Tom Jones (Ferrarioldman)
New member
Username: Ferrarioldman
Post Number: 5
Registered: 6-2002
| | Posted on Sunday, October 20, 2002 - 8:03 pm: | |
They are nuts with flat washer. 4 of them. 10mm socket will loosen them. You will just have to be careful when removing them. |
Michael N. (Man90tr)
Member
Username: Man90tr
Post Number: 700
Registered: 4-2001
| | Posted on Sunday, October 20, 2002 - 6:37 pm: | |
Thanks James,
Any special trick in avoiding losing these screws?
Michael |
James Selevan (Jselevan)
Junior Member
Username: Jselevan
Post Number: 175
Registered: 6-2002
| | Posted on Sunday, October 20, 2002 - 6:26 pm: | |
Michael - it is a separate piece that is easily removed by removing several 10 mm screws. Your back will know when you are finished, as you will have to lean over the car to get to all the 10 mm screws, but it is not difficult. I have done it several times. You can find the screws by simply running your hand along the contact between this removable "shield" and the chassis.
Hope this helps.
Jim S. |
Michael N. (Man90tr)
Member
Username: Man90tr
Post Number: 699
Registered: 4-2001
| | Posted on Sunday, October 20, 2002 - 11:45 am: | |
Thanks Ben,
When you raise the rear hood (engine cover), there is a small piece in the rear (right next to the rear plexiglass) that does not rise. It covers the alternator, compressor mainly. It is that piece i am talking about.
Michael |
Ben Lobenstein 90 TR (Benjet)
Member
Username: Benjet
Post Number: 824
Registered: 1-2001
| | Posted on Sunday, October 20, 2002 - 11:29 am: | |
Can I ask for more specifics on which peices you are talking about? I'm not sure exactly what you are referring to...
-Ben |
Michael N. (Man90tr)
Member
Username: Man90tr
Post Number: 697
Registered: 4-2001
| | Posted on Saturday, October 19, 2002 - 7:06 pm: | |
Guys,
I would love to take off the smaller inner engine shield of my TR to clean it good (louvers, underneath etc). I also would like to take put the small painted curved piece to clean inside that groove as well. Is this two separate pieces and what is the correct way to take the piece(s) off?
Thanks as always.
Michael |