| Author |
Message |
Paul Ferrari (Sonofmario)
New member
Username: Sonofmario
Post Number: 1
Registered: 10-2003
| | Posted on Sunday, October 12, 2003 - 5:44 pm: | |
Paul,
I also have the same problem. But I am a bit nervous about how much to grind away. Can you tell me how thick you ground it to? Did you grind it evenly or at an angle? Any chance you could post a picture?
Also, I know I am being paranoid here, but the head nuts are NOT reverse thread, right? I am having a devil of a time loosening these bolts. I hear the "pop" when it initially loosens. But then it actually seems to be harder to turn then it initially was. I am 99% certain that they are normal, but don't want to find out the hard way.
Your help would be greatly appreciated.
-Paul |
Paul Sloan (Sloan83qv)
Member
Username: Sloan83qv
Post Number: 393
Registered: 3-2001
| | Posted on Sunday, November 03, 2002 - 8:32 am: | |
Just grind the top a little bit and it works fine, had the same problem. |
Verell Boaen (Verell)
Member
Username: Verell
Post Number: 429
Registered: 5-2001
| | Posted on Saturday, November 02, 2002 - 5:29 pm: | |
Tim,
What part of the Baum wrench is preventing it from fitting on the bolts?
As we discussed, I'm about to reproduce this tool & I can probably take care of the problem in the one I'm making. |
Timothy Fulmer (Tf308)
New member
Username: Tf308
Post Number: 15
Registered: 5-2002
| | Posted on Saturday, November 02, 2002 - 2:47 pm: | |
Just received the baum head wrench..I can not get it to fit on bolts 3,1, and 5 (numbers are of the tightening sequence) Has anyone else had this problem or do I just have a bum (no pun intended) tool? Anyone compared this to the factory wrench? |