| Author | Message | ||
| John Delvac (Johndelvac)
Junior Member Username: Johndelvac Post Number: 186 Registered: 11-2001 |
I have the same problem too! Frank Parker said the lights in his 328 could be found on some junk-yard Alfa. Maybe he will share his info. | ||
| Tom Jones (Ferrarioldman)
New member Username: Ferrarioldman Post Number: 41 Registered: 6-2002 |
If you have strong fingernails or use like a wide blade scraper to lift the edge of the switch, it will pull right out. It has a spring clip on the ends on the switch. | ||
| Carmine Nicoletta (Ncarmine)
New member Username: Ncarmine Post Number: 46 Registered: 6-2002 |
VS Take the shifter gate out and the ashtray. Then, pop the set of four switches and you'll find two screws. After taking these out, the console lifts up. | ||
| VS (Vs1)
Junior Member Username: Vs1 Post Number: 67 Registered: 10-2002 |
First the dumb question - how are these removed? Will they just pull up out of the console or are they held in place by little tabs? | ||
| Tom Jones (Ferrarioldman)
New member Username: Ferrarioldman Post Number: 40 Registered: 6-2002 |
  Procedure for switch with 3 pots. Next time I'll try this with a scanner. | ||
| Tom Jones (Ferrarioldman)
New member Username: Ferrarioldman Post Number: 39 Registered: 6-2002 |
  Procedure for switch with 4 pots. Sorry I couldn't get it all in one picture. | ||
| Jim E (Jimpo1)
Intermediate Member Username: Jimpo1 Post Number: 1062 Registered: 7-2001 |
Tom, could you post the procedure? I have the same problem. | ||
| Tom Jones (Ferrarioldman)
New member Username: Ferrarioldman Post Number: 38 Registered: 6-2002 |
There are adjustment pots on these switches for those lights. There is a service bulletin, # 80-36 on how to adjust them depending on if you have 3 or 4 pots. Pull the switch and see how many pots you have and I would be glad to fax you a copy of it or I could post the procedure. | ||
| Mark Foley (Sparky)
New member Username: Sparky Post Number: 22 Registered: 3-2002 |
TM: Another item that caused mine to not work was the plug by the heater valve. The LEDs get their feedback through this plug. On my car the plug got a little wet. You can experiment with some jumpers. The problem could also be in the servo/feedback area..Mark | ||
| Dave328GTB (Hardtop)
Member Username: Hardtop Post Number: 351 Registered: 1-2002 |
I would try removing and cleaning contaacts first. The unit is pricey. Dave | ||
| tm328 (Tm328)
New member Username: Tm328 Post Number: 15 Registered: 4-2002 |
The last progressive LED light on my center console is not functioning.Does anyone know what the specs are and who stocks this item |