| Author |
Message |
Dr. Anthony Lizano (Docapl)
New member
Username: Docapl
Post Number: 33
Registered: 4-2002
| | Posted on Monday, February 24, 2003 - 12:20 pm: | |
Thanks. That is what I was looking for.
|
Rob Schermerhorn (Rexrcr)
Member
Username: Rexrcr
Post Number: 261
Registered: 11-2002
| | Posted on Monday, February 24, 2003 - 6:50 am: | |
Nominal thicknes is 28 mm, minimum is 26 mm. Runout max is 0.015 mm. As stated in WSM. |
JRV (Jrvall)
Member
Username: Jrvall
Post Number: 997
Registered: 11-2002
| | Posted on Sunday, February 23, 2003 - 11:08 am: | |
Min. allowable thickness should be stamped on the rotor hat somewhere. Measuring for thickness should be done in the middle of the friction surface and runout checked very near the rotor outer edge. |
Dr. Anthony Lizano (Docapl)
New member
Username: Docapl
Post Number: 32
Registered: 4-2002
| | Posted on Sunday, February 23, 2003 - 12:04 am: | |
Anyone know the thickness (original and minimum before replacement is indicated) for 360 brake rotors ?
Thanks. |