| Author |
Message |
Andy Falsetta (Tuttebenne)
New member
Username: Tuttebenne
Post Number: 27
Registered: 3-2003
| | Posted on Thursday, April 03, 2003 - 5:50 am: | |
I was told and have used 0.003 inch between the pad and rotor on the rear. To my knowledge there is no adjustment on the front.
Ciao |
DJParks (Djparks)
Junior Member
Username: Djparks
Post Number: 112
Registered: 2-2003
| | Posted on Wednesday, April 02, 2003 - 9:55 pm: | |
Seem to recall .004" clearance between pads and rotors on the rear. Not sure about the fronts, you'll have to ask an expert.
DJ |
DJParks (Djparks)
Junior Member
Username: Djparks
Post Number: 111
Registered: 2-2003
| | Posted on Wednesday, April 02, 2003 - 9:51 pm: | |
Try this, I have the article printed up and this is the site, www.ferrariforum.net/tech/view.php?id=13.
You can also try, the 914 caliper rebuild article which, as I understand, has a lot in common with F*calipers, www.pelicanparts.com/techarticles/914_caliper_rebuild.htm.
I know I will be doing mine some day and I know I'll never find the thread. I am making a binder of all of the how to DIY articles for future reference. I keep it in the shop for quick reference It's paying off already.
Hope this helps, DJ |
Mike Procopio (Pupz308)
Junior Member
Username: Pupz308
Post Number: 236
Registered: 10-2002
| | Posted on Wednesday, April 02, 2003 - 9:35 pm: | |
I, too, would be interested in any info on this... Installing rebuilt calipers in a few days. |
Jerry W. (Tork1966)
Member
Username: Tork1966
Post Number: 599
Registered: 7-2001
| | Posted on Wednesday, April 02, 2003 - 7:56 pm: | |
Any advise would be appreciated. I just rebuilt my calipers and had my rotors ground and plated, how far should I turn in each side of the adjusting screws on the pads? Thanks so much, Jerry. |