Joe Calareso (308man)
New member
Username: 308man
Post Number: 4
Registered: 2-2002
| | Posted on Thursday, April 10, 2003 - 11:50 am: | |
The battery bracket assembly on my '84' 308qv has a different set up than shown in the parts book diagram shows. It has a contoured hard rubber piece (about 1" high x 3" long) that sits on top of bracket and a 2" bolt/washer that runs through it, and the bracket, and screws into the frame. Is this a mickey mouse setup or did Ferrari change this with 'newer' 308's?
The parts book diagram shows a washer and nut holding down the bracket to what must be a fixed stud sticking up from frame?
Also..is there supposed to be a rubber coating or mat on the surface where the battery sits?
feedback appreciated. |