Author |
Message |
Keith Mahan (Gyrokeith)
New member Username: Gyrokeith
Post Number: 31 Registered: 4-2003
| Posted on Tuesday, July 15, 2003 - 6:06 pm: | |
I have seen the post and checked my senders (ignition). I was wondering about the other pins. When I got the car there was some ignition problems, wires, caps, connectors. I swaped everything and still have errant surging and missing, mostly on one bank. The cold start valve, frequency valve and pressures seem ok. It runs poorly at all rpms, worse lower and all temps, worse hotter. It has started running differently since I gave it a double dose of Techron. I have purchased new injectors and o-rings but haven't installed them yet. I'm pretty sure some of the injectors are clogged. BTW.... I saw the thermostat. It sure looks a lot like a Fiat x1/9 thermo. |
Verell Boaen (Verell)
Member Username: Verell
Post Number: 963 Registered: 5-2001
| Posted on Tuesday, July 15, 2003 - 4:56 pm: | |
Keith, The archives have some info on the pinout. See Matt Boyd's post #63 in this thread: http://www.ferrarichat.com/discus/messages/256120/233442.html Pin 3 - TDC Sensor for cyl 1-4 Pin 5 - TDC sensor for cyl 5-8 Pin 9 - Ground With this as a start, you should be able to figure out the other connections. BTW, what problem are you chasing? |
Steven R. Rochlin (Enjoythemusic)
Member Username: Enjoythemusic
Post Number: 560 Registered: 4-2002
| Posted on Tuesday, July 15, 2003 - 7:50 am: | |
Keith, After looking at my parts, service, and owner's manual, they show the diag socket on pages 73-75 of the owner's manul, but does not show exact pin out configuration (which pin equals what). i have ALL documentation on CD and can copy for you and mail. E-mail me at [email protected] and will mail you a copy :-) Enjoy the Drive, Steven R. Rochlin
|
dave handa (Davehanda)
Intermediate Member Username: Davehanda
Post Number: 1250 Registered: 5-2001
| Posted on Tuesday, July 15, 2003 - 4:23 am: | |
You'll find a picture on Ebay...I saw one tonight (last night?), the thermostat that is... |
Keith Mahan (Gyrokeith)
New member Username: Gyrokeith
Post Number: 29 Registered: 4-2003
| Posted on Tuesday, July 15, 2003 - 4:14 am: | |
Does anyone have the pinout on a 308 QV diagnostic connector? I'm still troubleshooting and don't have any factory manuals.. Also, does anyone have physical dimensions for the QV thermostat? Even a picture would be helpful. Thanks.. |
|