Interior out.... Log Out | Topics | Search
Moderators | Edit Profile

FerrariChat.com » Technical Q&A Archives » Archive through August 05, 2003 » Interior out.... « Previous Next »

Author Message
Lee Pierce (Leepierce)
Junior Member
Username: Leepierce

Post Number: 175
Registered: 1-2003
Posted on Monday, July 21, 2003 - 2:09 pm:   

Good God...those look like new! I'll definitely be searching the archives for sources when I decide to replace things like that, which my interior could really use.
Randall (Randall)
Member
Username: Randall

Post Number: 610
Registered: 1-2003
Posted on Monday, July 21, 2003 - 1:01 am:   

These label plates:
Upload
Upload
Lee Pierce (Leepierce)
Junior Member
Username: Leepierce

Post Number: 174
Registered: 1-2003
Posted on Sunday, July 20, 2003 - 9:30 pm:   

What do you mean by "label plates", 'cause I think I'm in dire need of some? Are they the little chromed plastic rings where the stickers for the AC/heat/choke/aeriel are?
dave handa (Davehanda)
Intermediate Member
Username: Davehanda

Post Number: 1341
Registered: 5-2001
Posted on Sunday, July 20, 2003 - 4:01 pm:   

I have upgraded three cars with the light bulb upgrade and have to admit that the reostat by-pass is much preferred. Check the archives for details. Window switches can be torn down and cleaned, rather than replaced. Definitely replace the label plates on the console. Shop around though, as there are cheaper sources than italiancarparts.com for them. Try Ebay and check the archives for additional, more reasonable cost alternatives for the label plates.
Verell Boaen (Verell)
Member
Username: Verell

Post Number: 981
Registered: 5-2001
Posted on Saturday, July 19, 2003 - 10:56 pm:   

Well, just about anything that slides or pulls eg: temp & vent cables, pedals, clutch & accel. cables, steering wheel... Should get lubricated.
Randall (Randall)
Member
Username: Randall

Post Number: 609
Registered: 1-2003
Posted on Saturday, July 19, 2003 - 10:48 pm:   

I just finished tearing out most of my interior(seats, door panels, center console) to redye everything with Leatherique. I was wondering what else I should do besides clean everthing while these pieces are out? I was thinking about new window switches and label plates. But what about lights for the gauges; can those be upgraded? What about items to grease/examine for wear? As always thanks for the help.

Add Your Message Here
Posting is currently disabled in this topic. Contact your discussion moderator for more information.

Topics | Last Day | Last Week | Tree View | Search | Help/Instructions | Program Credits Administration