| Author |
Message |
Carl Jones (Carl888)
New member
Username: Carl888
Post Number: 7
Registered: 7-2003
| | Posted on Thursday, August 21, 2003 - 4:54 pm: | |
Hi Mitch,
Thanks for the information. What I needed though, and I'm sorry for not explaining myself, are the chassis measurements in mms. The information is usually provided in the workshop manual for measuring a car after accident damage. I need to know the specifically the width of the upper front wishbones (i.e. the distance between them side to side) Thanks for any information. Regards,
Carl.
|
Mitch Alsup (Mitch_alsup)
Member
Username: Mitch_alsup
Post Number: 986
Registered: 4-2002
| | Posted on Thursday, August 21, 2003 - 9:20 am: | |
Front camber: -0.5 to -0.8 d
Front Caster: 7 d
Front Toe: 2mm In
Front Ride Height: 163mm
Front weight: 730 pounds/corner +/- 20 lb
Rear Camber: -2.0
Rear Toe: 2mm In
Rear Ride Height: 187mm
Rear weight: 950 pounds/corner +/- 20 lb
Ride heights are measured from the flat and level ground to the center of the pivot bolt at the rear of the lower control arm. 1/2 load of fuel, with driver and passenger weights. |
Carl Jones (Carl888)
New member
Username: Carl888
Post Number: 6
Registered: 7-2003
| | Posted on Wednesday, August 20, 2003 - 10:17 pm: | |
Can anyone supply me some 355 chassis alignment specs please. I need to know basic measurements like control arm location, ride height, distance measuring points etc. Any information most appreciated. Regards Carl.
|