HT lead positions Dino 246 | FerrariChat

HT lead positions Dino 246

Discussion in '206/246' started by Adds406, Oct 16, 2014.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. Adds406

    Adds406 Rookie

    May 17, 2011
    26
    #1 Adds406, Oct 16, 2014
    I was trying to change the HT leads on a Dino 246 and even though I carefully tried to pull them off one at a time I accidentally muddled them. has anyone got a drawing of the distributor cap that shows which lead goes where.
    if not a photo might help.

    thanks for your help

    you can email me pictures on [email protected]

    Adam
     
  2. TonyL

    TonyL F1 Rookie

    Sep 27, 2007
    3,841
    Norfolk - UK
    Full Name:
    Tony
    #2 TonyL, Oct 17, 2014
    Rotate the engine by hand until the timing mark on the pulley coincides with the PMS (TDC) mark on the timing tag next to the pulley.

    Remove the dizzy cap and the rotor arm should be pointing at approx. 4 o clock.

    Note the corresponding terminal on the cap...this is No 3. Everything on the dino is timed to NO3

    Firing cycle is anti clockwise 1,4,2,5,3,6

    So the next one anti clockwise is 6, the next 1 etc etc
     
  3. Nuvolari

    Nuvolari F1 Veteran
    Owner Silver Subscribed

    Sep 3, 2002
    6,422
    Toronto / SoCal
    Full Name:
    Rob C.
    #3 Nuvolari, Oct 17, 2014
    Last edited by a moderator: Sep 7, 2017

Share This Page