GTS Heater valve/Choke knob installation | FerrariChat

GTS Heater valve/Choke knob installation

Discussion in '206/246' started by Cali458spider, Jun 26, 2017.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. Cali458spider

    Cali458spider Rookie

    Jan 16, 2014
    14
    San Diego
    Full Name:
    Rich
    #1 Cali458spider, Jun 26, 2017
    Just changed the heater valve/choke labels on my GTS. I cracked the the knobs when I removed them to change the labels. Just bought all new knobs, is there a secret to installing them as they appear to have a round hole but the end of the lever is not round, its kind of flat - Any help would be greatly appreciated!
     
  2. swift53

    swift53 F1 Veteran
    Rossa Subscribed

    Nov 17, 2007
    6,735
    E.S.
    Full Name:
    Alberto
    #2 swift53, Jun 26, 2017
    Could make the hole elongated for the flat of the lever, or make the end of the lever round.

    Epoxy, or similar in either.

    It is a case of your knobs belonging to another model Ferrari.

    There really is no secret on installing.

    Regards, Alberto
     
  3. Motob

    Motob Formula 3
    Professional Ferrari Technician

    Nov 11, 2003
    2,239
    Frederick, Maryland
    Full Name:
    Brian Brown
    #3 Motob, Jun 27, 2017
    You don't have to remove the knobs to change the labels. Just carefully push one side of the label up and the other side down, and it will easily fit over the knobs.
     

Share This Page