Hi Guys Wanted to know if someone has successfully done this? I've picked up a new cluster (ebay) due to my old one's lights going out. Tried fitting it in but it throws a whole bunch of errors and the Manettino switch goes out of sync. Looks like the panel needs to be flashed or re-synced to the car in some way, any ideas how I would get this done? Cheers Jay
I've tried, I sent the panel to a repair specialist here and they said the inverters within the dash were faulty and the dash just burns the new filament
FAI can fix your old one, but they are across the pond. They repaired a duff power supply in mine. Franchorchamps of America, Inc. 935 Sunset Dr Suite A Costa Mesa, CA 92627 (949) 631-6373 Rod Drew [email protected] Will White Home
New cluster matches body type? Coupe and spyder are not compatible nor is F1 and 6spd. Also not sure if clusters in later model yr would be backward compatible either.
Thanks for the link, I'll give them a shout. Wasn't aware that it was based on body type. Would it take actually sending it to Marennallo to actually change the settings if that the case?
My friend change out his at one point and was told due to spider having top up / down status. F1 has Gear selection feedback and manual doesn't. But has not confirm if this will cause an issue.
Same instrument panels in the Coupes and Spiders. All those differences are in the 8 Mb chip in the instrument panel. An SD3 can set up the panel for F1/3 pedal, steel/CCM, Coupe/Spider, TPMS/no TPMS, etc. Too expensive to do it any other way. http://www.ricambiamerica.com/product_info.php?products_id=262477