Front - 8.5JX20 PCD 5x14.3 Dia 67.1мм ET35 Rear- 10.5JX20 PCD 5x14.3 Dia 67.1мм ET35 Can I use this wheel rims, guys?
ET size is smaller than need for 612 (Front 8J X 20 ET 43.5 mm, Rear 10J X 20 ET 51.1 mm), can i use this rims?
Here are the specs for 612 wheels. Make your own call. Make a drawing of the wheels from the side. The OEM offset is 43.5 mm and 51.1 mm outside from the centerline of the wheel. The ones you are looking at have 8.5 mm and 16.1 mm less offset, but the wheels are 1/2" wider, so 6.3 mm extra on each side of the wheel. Fronts should work with no spacers. Rears will sit 10 mm further in than OEM, so rear spacers will probably make them look better. 25 mm spacers would have the rear wheels sit 15 mm futher out in the wheelwell, which should look better. I run 25 mm Hill Engineering Type 2 spacers (separate bolts for spacer, stock bolts for wheels) with OEM wheels and they look great. 612 Five Spoke F 18”, R 19”, 5 X 114.3 mm Front 8J X 18 ET 43.5 mm , R 10J X 19 ET 51.1 mm Five Spoke Modulars 19”, 5 X 114.3 mm Front 8J X 19 ET 43.5 mm, Rear 10J X 19 ET 51.1 mm Challenge Monolithic 20”, 5 X 114.3 mm Front 8J X 20 ET 43.5 mm, Rear 10J X 20 ET 51.1 mm