Need 599 Sticky buttons interior trim removal info | FerrariChat

Need 599 Sticky buttons interior trim removal info

Discussion in '612/599' started by cwwhk, Feb 15, 2015.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. cwwhk

    cwwhk Formula 3

    Nov 13, 2003
    1,535
    Hong Kong, Tokyo
    Full Name:
    Wayne
    I have sticky buttons and want to remove them from car to clean and refinish. Does anyone know how to remove the trim plate over the buttons? Specifically the door lock/unlock/ sensor trim plate at the center console, and the display/mode trim plate on the dash.

    Do I just pry them out? Any specific direction to pry or technique to use?

    Thanks in advance for helpful info.

    Regards,
    Wayne
     
  2. Doctor Mark

    Doctor Mark Formula Junior

    Dec 15, 2005
    870
    Georgia
    Full Name:
    Mark Gronsbell
    plate with lock unlock buttons just pries out
     
  3. cwwhk

    cwwhk Formula 3

    Nov 13, 2003
    1,535
    Hong Kong, Tokyo
    Full Name:
    Wayne
    Thanks.

    Tried to pry it out with two plastic wedges on left and right but the trim plate does not budge.
     
  4. Doctor Mark

    Doctor Mark Formula Junior

    Dec 15, 2005
    870
    Georgia
    Full Name:
    Mark Gronsbell
    Try inserting on one side only until that side is raised. Then move to the other side. Worked for me. Use thin wedges.
     

Share This Page