TR flywheel removal | FerrariChat

TR flywheel removal

Discussion in 'Boxers/TR/M' started by lear60man, Sep 29, 2014.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. lear60man

    lear60man Formula 3

    May 29, 2004
    1,829
    Los Angeles
    Full Name:
    Christian
    #1 lear60man, Sep 29, 2014
    Special tool or what? Im referring on how to get the 8 x 17mm bolts out on the last flywheel with the starter ring. How do I keep it from spinning the crankshaft.

    Thanks :)
     
  2. Rifledriver

    Rifledriver Three Time F1 World Champ

    Apr 29, 2004
    33,965
    Austin TX
    Full Name:
    Brian Crall
    #2 Rifledriver, Sep 29, 2014
    Last edited: Sep 29, 2014
    A large screw driver through the timing port holding the ring gear. Those are 10mm bolts.
     
  3. lear60man

    lear60man Formula 3

    May 29, 2004
    1,829
    Los Angeles
    Full Name:
    Christian
    #3 lear60man, Sep 29, 2014
    Thank You!! That did the trick. 10mm I have the later 1990+ clutch and the rear flywheel is held on with 17mm bolts.
     
  4. Rifledriver

    Rifledriver Three Time F1 World Champ

    Apr 29, 2004
    33,965
    Austin TX
    Full Name:
    Brian Crall
    #4 Rifledriver, Sep 29, 2014
    No, they are all 10mm. You are talking about a wrench. That has nothing to do with the fastener size. The size of the head is not a fastener size.
     
  5. lear60man

    lear60man Formula 3

    May 29, 2004
    1,829
    Los Angeles
    Full Name:
    Christian
    #5 lear60man, Sep 29, 2014
    You are absolutely correct...long day in the sun for me. And thanks again for the screwdriver tip.
     

Share This Page