rad. fans sensor switch ? | FerrariChat

rad. fans sensor switch ?

Discussion in 'Mondial' started by bigeasy, Oct 27, 2014.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. bigeasy

    bigeasy Formula Junior

    Dec 31, 2012
    368
    #1 bigeasy, Oct 27, 2014
    Both my Radiator fans run the minute I switch the key on, figured PO must have bypassed the temp. sensor. Can anyone tell me where this sensor is located? nothing mounted to the radiator, wiring diagram shows something near the battery compartment, is that correct? How should wiring on the sensor look when properly wired?

    Thanks.
     
  2. Steve Magnusson

    Steve Magnusson Two Time F1 World Champ
    Lifetime Rossa

    Jan 11, 2001
    25,150
    30°30'40" N 97°35'41" W (Texas)
    Full Name:
    Steve Magnusson
    #2 Steve Magnusson, Oct 27, 2014
    Bottom tank of the radiator is the stock location.
     
  3. bigeasy

    bigeasy Formula Junior

    Dec 31, 2012
    368
    #3 bigeasy, Oct 27, 2014
    Thanks Steve, I didn't get under the car and look, didn't see any wires going in that direction, I guess for good reason, bypassed.
     
  4. Steve Magnusson

    Steve Magnusson Two Time F1 World Champ
    Lifetime Rossa

    Jan 11, 2001
    25,150
    30°30'40" N 97°35'41" W (Texas)
    Full Name:
    Steve Magnusson
    #4 Steve Magnusson, Oct 27, 2014
    Not sure how "sealed up" the bottom of the Mondial QV coachwork is, but it may be more a case of digging around from the top near the corners of the radiator (as it is on a 308).
     
  5. ozmondy

    ozmondy Formula Junior

    Oct 30, 2013
    307
    N.T, Australia
    Full Name:
    Peter
    #5 ozmondy, Oct 28, 2014
    My euro QV is sensed at the radiator and is accessible from under the front hood
     
  6. miketuason

    miketuason F1 World Champ
    Owner Silver Subscribed

    Feb 24, 2006
    15,541
    Cerritos, CA.
    Full Name:
    Mike
    #6 miketuason, Oct 28, 2014
    From the driver seat (LHD) it's on the bottom right corner of the rad. Somebody must have put a jumper on the wire terminal.
     

Share This Page