8 pole harness pin removal tool

http://pages.ebay.com/link/?nav=item.view&alt=web&id=161320386116&globalID=EBAY-US
I use these. Might find them at the local parts store.

 

Yes a Round Tube tool made by AMP. Looks like a screwdriver, but with a very thin walled tube that fits over the contact.
Or a very small Moody Jewlers screwdriver.
Push the contact into the housing to free up the two clasps, reach in with the screwdriver from the wire end and bend the clasps into the hollow connector,,,
Then pull out on the wire.
Repeat if needed.

Good luck.

Edwardo

 

I am doing some work on my car and I can't seem to find that round harness, could you let me know in detail where to find it? With pictures if possible?

 

Engine Pin Harness Connectors are about 18" rear of the ignition coils,, under the trim.
Good luck.

Edwardo

 

I looked and still can't find it. When you say 18" rear of the ignition coils and under the trim, did you mean in the trunk? Because I have removed all the trim in the trunk and there is nothing there. The jetronic computer is in the right side of the trunk, but there is nothing in the left side, as you can see in the picture. Is it perhaps inside the LR fender? Do I access it through the wheel well?
Image Unavailable, Please Login

 

Yes Sir Robo,

A just snapped a photo. worth a 1000 words.


Edwardo
Good luck.
Image Unavailable, Please Login

 

Found them, Thanks.