© 2024 DRIVEN LIFESTYLE. All rights reserved.
This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.
Got it - thanks. Appreciate the clarification.
Dflett- when you say "bushing in the steering rack" do you mean the rack support bushing (part #103287) or some other bushing?
I have a "clunk" coming from the right front whenever a bump is hit at speed, say over 20 mph. It only comes from the front right and not the...
Great - thanks. Could not see that in any of the diagrams I found.
[ATTACH] Working on the front disc brakes of my 1980 308. As I am knocking out the race on the inside bearing - what pops a split retainer...
I've read just about every post I can find regarding timing belt replacement and I'm ready to get started. 1980 GTSi, 61K. Just need the parts,...
I had this exact same problem on my drivers door on my 80 308. Door wouldn't close, seem to latch but then it would pop open to that first notch....
I'd be interested to learn what you find out. I'm at the same fork in the road of restore or replace. With the right leather and advice it does...
Well, I was finally able to wrap up the repairs today. Thanks for all the tips and advice. Followed all the steps on this site for accessing and...
I'm in the same boat - just cracked the black nylone fuel line into the FD... Maybe it's in this thread but I can't seem to find where to buy the...
Thanks everyone to the feedback and tips. Feeling a little stupid if all this was a result of that hose I failed to reconnect, but if it all...
Just off the engine - not out of the exhaust best I can tell. Oil on exhaust was smoking like hell, but not from exhaust pipe outlets. (Note to...
Took the 308 (1980, 2V, GTSi, 60K miles, just got it) for a mountain run today but didn't get far. Lost all my oil, ran the temp up, and lost...
Thanks. I'll see if I can get my hands on a 4 gas exhaust analyzer (I think a buddy has one) and check the upstream/downstream numbers. I'll...
If I went any leaner on the adjustment the engine would die...so following on to Rifledriver's comment that .47 post cat may still be rich, how...
I used the State's measuring device :-) While I want the correct mix, it was the emissions test I needed to pass.
Thank you everyone for the directions and tips. Getting the plug out proved to be a bit of a bugger but after that I was able to dial it in and...
Any way to check the cats without taking them off? My guess is at 61K they are probably shot if they are original (guessing they probably are by...
Thanks for the input on the O2 sensor (no wonder I was having trouble locating one!) Yes, it has cats. One more question: can I expect to...
Thanks - didn't know that was a plug but hadn't messed with it yet. The reason for the adjustment, from my original post: "...I just took it...