Snap, gone gone it aint coming back | FerrariChat
Buy

Snap, gone gone it aint coming back

Discussion in '308/328' started by marc.l, Apr 6, 2009.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

Page 1 of 3
  1. marc.l

    marc.l Karting

    Feb 25, 2008
    78
    #1 marc.l, Apr 6, 2009
    Got all my new hoses on, refited my fully rebuilt carbs, fitted the new s/s tudi manifold and sports exhaust, fitted the new fuel pump and the rebuilt fuel tanks. New filter and 11 ltrds of oil, new coolant and it was time to go. Its started and ran like a dream sounded fan bloody tastic good oil pressure and going great .... until a cam belt snaped.
    going to cry into some alcahol. gutted is not the word
     
  2. BigTex

    BigTex Seven Time F1 World Champ
    Owner Rossa Subscribed

    Dec 6, 2002
    79,380
    Houston, Texas
    Full Name:
    Bubba
    #2 BigTex, Apr 6, 2009
    Chin up, mate!

    Only one side hopefully.........a shame about the timing of it all though, after you were showing all the love.....
     
  3. Simon^2

    Simon^2 F1 World Champ

    Oct 17, 2005
    12,313
    At Sea Level
    #3 Simon^2, Apr 6, 2009
    Heart breaking. Have a pint or 10 on me... I'm going to grab one in solidarity. Don't know what else to say...
     
  4. marc.l

    marc.l Karting

    Feb 25, 2008
    78
    #4 marc.l, Apr 6, 2009
    I think some thing broke in the drive chain and snaped the belt rather than the belt snaping and doing the damage . Whats the likely damage parts wise ?
     
  5. jimshadow

    jimshadow F1 Veteran
    Lifetime Rossa Owner

    Feb 19, 2006
    6,251
    Indiana/North Carolina
    Full Name:
    JIM
    #5 jimshadow, Apr 6, 2009
    This is really heartbreaking! Sorry to hear this. If you caught it quickly, the damage *could* be minimal, however, the likely scenario is that a piston or more met a valve. Could be anything from a dented piston crown, to a bent/broken valve to a scored liner. Take a look at this thread to see what you're in for rebuild wise: http://www.ferrarichat.com/forum/showthread.php?t=227178

    Keep us posted.

    JIM
     
  6. BigTex

    BigTex Seven Time F1 World Champ
    Owner Rossa Subscribed

    Dec 6, 2002
    79,380
    Houston, Texas
    Full Name:
    Bubba
    #6 BigTex, Apr 6, 2009
    You can short block to a new rebuilt motor for 12K exchange......so that's the upper end!

    Maybe just some nicked piston crowns and a new head retro fit is all you need....look at at he bright side, no more sodium valves!

    It may have been one of them that snapped, and jammed up the valvetrain???
     
  7. marc.l

    marc.l Karting

    Feb 25, 2008
    78
    #7 marc.l, Apr 6, 2009
    It may have been one of them that snapped, and jammed up the valvetrain???

    It has got to be some thing like that, the valve train jammed and caused the belt to break. I can see where the tooth on the cam dugi nto the belt as it seazed. O well engine rebuild to fast road spec on the way
     
  8. AHudson

    AHudson F1 Rookie
    Silver Subscribed

    Jul 7, 2005
    2,781
    Florida
    Full Name:
    Adams Hudson
    #8 AHudson, Apr 6, 2009
    Ugh, I'm sick FOR you on that; very disheartening, but you've got a good attitude and even better advice on this board. I'm a sympathizer, wishing you a speedy solution. It'll be better than ever.
     
  9. marc.l

    marc.l Karting

    Feb 25, 2008
    78
    #9 marc.l, Apr 6, 2009
    I`ve put her back in the garage and going to have a look in the Morn, I managed 1 tin of beer..... going to rob the super car fund to do the repairs so looks like its going to be a Vanquish rather than a Diablo. its a hard life
     
  10. Helmut

    Helmut Formula Junior

    Dec 11, 2004
    640
    #10 Helmut, Apr 6, 2009

    The biggest PITA is probably to get the engine out. But from what I have seen on my engine which was just completely rebuilt its not that bad. Once you got it out you take it apart bring it to a excellent machine shop and have him put in some new pistons and new valves. You can get the valves, gaskets etc at GT carparts for pretty cheap. In case you still have stock pistons and you would like to just replace some of them I have 8 in very good condition stock pistons.
    If its the rear bank you might not even have to pull the engine. Labor of Love....

    Helmut
     
  11. brook308

    brook308 Formula Junior

    Oct 19, 2007
    346
    SS Coast, Australia
    Full Name:
    George
    #11 brook308, Apr 7, 2009
    Hi Mark,

    Sorry to hear about the damage, gutwrenching feeling I know.

    I've just finshed rebuilding my 308 after a piece of brass fell out of my carb sync tool into #2 cyl.

    Are you sure nothing fell down into the cam belts after the work was done on the car?

    I had a very near miss just after my rebuild when one of the nuts that holds the air cleaner cover on fell off.

    The nut fell down and landed on the idler pully for the air-con compressor and was then launched into the engine bay cover leaving a small dent.
     
  12. jeffQV

    jeffQV F1 Rookie

    Feb 13, 2004
    2,976
    NZ
    Full Name:
    jeff
    #12 jeffQV, Apr 7, 2009
    Bugger! What a thing to have happen. Hopefully not too serious, the fact the engine was at low RPM should help. Can I mention a four letter F word here? OK, Ford! I had a belt go whilst stationary at some lights a few years ago, just went, no warning etc. No damage either so all crossed from here, let us know! and of course Good Luck :)
     
  13. marc.l

    marc.l Karting

    Feb 25, 2008
    78
    #13 marc.l, Apr 7, 2009
    Got up this morning and started the strip dowm. Cam covers off and can see no damage, carbs off and all the inlet valves are intact. Spark plugs out and no holed pistons. I maybe a very lucky person.
     
  14. marc.l

    marc.l Karting

    Feb 25, 2008
    78
    #14 marc.l, Apr 7, 2009
    Compeshion good on all cylinders and the belt breakage was caused by a jubile clip some how finding its way in to the cam covers. The new belts are on and the build up begins.
     
  15. Glassman

    Glassman F1 World Champ
    Rossa Subscribed

    Apr 23, 2002
    15,236
    Montana, Oregon, Hawaii
    #15 Glassman, Apr 7, 2009
    So the belt is actually broken? And there is no valve or piston damage? What is a jubile clip? Any pictures?
     
  16. PAP 348

    PAP 348 Ten Time F1 World Champ
    Lifetime Rossa Owner

    Dec 10, 2005
    100,220
    Mount Isa, Australia
    Full Name:
    Pap
    #16 PAP 348, Apr 7, 2009
    Wow! Sorry to hear of this mate!! :(:(

    I hope you get her back on the road soon! :):)
     
  17. marc.l

    marc.l Karting

    Feb 25, 2008
    78
    #17 marc.l, Apr 7, 2009
    A jubile clip is a worm drive hose clip and yes it droke the belt, will post some pics up latter.
    Nearly done.........
     
  18. santacaferacer

    santacaferacer Karting

    Jan 6, 2009
    76
    #18 santacaferacer, Apr 7, 2009
  19. marc.l

    marc.l Karting

    Feb 25, 2008
    78
    #19 marc.l, Apr 7, 2009
    Shes up and running again, lucky or what ?. Still a few jobs to do, I replaced the vacum hose to the servo with silicon hose and it just dose not have enougth strenth in it. Going to replace with rubber hopefully with out taking the fuel tank out again. Just leaves the carbs to balance and it will be back on the road.
     
  20. Artvonne

    Artvonne F1 Veteran

    Oct 29, 2004
    5,379
    NWA
    Full Name:
    Paul
    #20 Artvonne, Apr 7, 2009
    Does England have a Lottery? If you broke a belt with the engine running and didnt bend valves or otherwise mash anything up, it may very well be the first Ferrari in history to pull it off. Absolutely amazing. I doubt anyone would have believed it possible had the question been posed to its possibility.
     
  21. ZiFF

    ZiFF Formula Junior

    Mar 30, 2009
    323
    #21 ZiFF, Apr 7, 2009
    Wow, you don't waste any time. Nice save!
     
  22. marc.l

    marc.l Karting

    Feb 25, 2008
    78
    #22 marc.l, Apr 7, 2009
    I spoke to Ron at Superformance before I started to strip it down . I asked the chances of it having big damage and was told that they dont always smash when a belt brakes. Lucky it was ticking over a bit on the slow side (around 5-600 rpm) as i had just rebuilt the carbs and had not set them up. I will post some pics tommorow of the hose clamp (jubile clip) and the belt and the nick in the bottom pully were the clip broke the belt.
     
  23. PAP 348

    PAP 348 Ten Time F1 World Champ
    Lifetime Rossa Owner

    Dec 10, 2005
    100,220
    Mount Isa, Australia
    Full Name:
    Pap
    #23 PAP 348, Apr 7, 2009
    Wow!! Crazy **** Marc! :D:D
     
  24. cmt6891

    cmt6891 Formula 3

    Feb 25, 2008
    1,338
    Encino, Ca
    Full Name:
    Carl T
    #24 cmt6891, Apr 7, 2009
    You are one lucky dude ! I guess they key point is to address the situation immediatly to minimize damage...HAHAHA
     
  25. BigTex

    BigTex Seven Time F1 World Champ
    Owner Rossa Subscribed

    Dec 6, 2002
    79,380
    Houston, Texas
    Full Name:
    Bubba
    #25 BigTex, Apr 7, 2009
    Last edited by a moderator: Sep 7, 2017
    It has everything to do with the duration to shut down.....quick thinking saved the day!!

    Hearty congratulations, I'll keep drinking, only in celebration! LOL!
    Image Unavailable, Please Login
     
Page 1 of 3

Share This Page