308 Windshield Wiper Motor Removal | FerrariChat

308 Windshield Wiper Motor Removal

Discussion in 'Technical Q&A' started by ckracing, May 17, 2009.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. ckracing

    ckracing Formula Junior

    Joined:
    May 20, 2006
    Messages:
    728
    Location:
    Jacksonville,Florida
    Full Name:
    Charles
    Hi Guys, what are the basic steps for removing the Windshield Wiper Motor?
    Thanks in advance.
    Charlie
     
  2. greg328

    greg328 F1 Rookie

    Joined:
    Nov 17, 2003
    Messages:
    4,209
    Location:
    Austin, TX USA
    Full Name:
    Greg
    It's accessed through the front left wheel well. If memory serves, you need to remove the panel closest to the cabin, then have a look. You'll see the motor in there...

    Good luck,
    Greg
     
  3. bert308

    bert308 Formula 3

    Joined:
    Nov 30, 2002
    Messages:
    1,776
    Location:
    Roermond Netherlands
    Full Name:
    Bert Kanters
    Here is mine, left wheel well acces panel removed. First you have to remove the bar that goes to the wipers, it is locked with an U shaped open ring (don't know the english name or even in dutch). Then there are 3 bolts to remove but I couldn't remove the 3rd because the lever was in the way, so you might first park your wipers in another position then rest if the motor still works.
    Image Unavailable, Please Login
     
    Last edited by a moderator: Sep 7, 2017
  4. miketuason

    miketuason F1 World Champ Owner Silver Subscribed

    Joined:
    Feb 24, 2006
    Messages:
    15,811
    Location:
    Cerritos, CA.
    Full Name:
    Mike
    Bert, looking at you pic, I can say that the wiper motor is exactly the same as the one on my Lancia Scorpion/Monte Carlo
     
  5. bert308

    bert308 Formula 3

    Joined:
    Nov 30, 2002
    Messages:
    1,776
    Location:
    Roermond Netherlands
    Full Name:
    Bert Kanters
    Ha, I have a Montecarlo too. When one day the water drain from where the wiper motor sits was blocked, the motor was flooded and after that it doesn't park the wipers anymore which means the interval doesn't work either. I should remove it one day and clean the contacts or replace, I think the Alfasud also has the same motor and I have some of those.
     
  6. miketuason

    miketuason F1 World Champ Owner Silver Subscribed

    Joined:
    Feb 24, 2006
    Messages:
    15,811
    Location:
    Cerritos, CA.
    Full Name:
    Mike
    Yes, they usually get rusted and break off, but if not, clean it real good and apply sealant around the top plastic cover where the contact point is located.
     
  7. ckracing

    ckracing Formula Junior

    Joined:
    May 20, 2006
    Messages:
    728
    Location:
    Jacksonville,Florida
    Full Name:
    Charles
    Thanks Bert for the great picture and the great hints on how to remove the wiper motor.
    I will check to see if I am getting voltage to the motor before I pull it. It could be the wiper switch?
    Charlie
     
  8. Du_Man

    Du_Man Formula Junior Silver Subscribed

    Joined:
    Apr 23, 2003
    Messages:
    320
    Location:
    Dallas, Texas
    Full Name:
    Derek
    Image Unavailable, Please Login

    Can I add to this older post? I am removing the wiper motor assembly form my 80' 308 - the wiper studs will not slip down. Is the black ring just a washer or is it threaded? This trough was repainted black (should be color red as the rest of the car).....so I am not sure if the black paint is sticking up everything. Tapping with a hammer will not knock it through and a thin blade will not lift the black ring.
     

Share This Page