360 Spider Convertible Top Fluid Replacement

I just had my top serviced last week. You have to take off the rear panel (either carpet or leather) directly behind the passenger seat and THEN relocate the electronics to get to the fluid container. NOT a smart design at all.

I WOULD not attempt it UNLESS you have extensive mech. skills; which I am smart enough to know that I do not.

Hope this helps

 

Its really not rocket science... panel is behind passengers seat in corner. Remove that (you may break the cheap 50 cent trim clips pulling it off) remove the cylinder from the bracket, turn it so you can fill it.


There are detailed directions here if you do a search, I checked/topped off to max fill line (took very little) mine & its about a 15 minute task.. other than breaking the trim clips (ricambi has them) all went well. Make sure you use proper fluid, again the post on here with instructions tells you what to get- mercedes benz makes compatible fluid if I remember right

Chris

 

You can do it yourself, i did.

 

I have topped my fluid off once. Not a big deal.

However, I have not heard about having replacing the fluid.

Is there a documented time interval for this?

If the top is slow or stops working sound like there is a leak, not worn fluid..

 

Done it twice on two cars and it's very simple.

Here's the link and place the thanks to the right Peeps:

http://ferrarichat.com/forum/showthread.php?t=140091

 

I admire those of you that have the ability to tackle these tasks. With my luck, I would break several components and still have to take the car to the shop.

After reading the post on HOW to """" I really think the $100 I spent was well worth it. Also they had to remove a subwoofer that is behind the passenger seat (only took 5 minutes or so).

Please keep us informed on the outcome.

 

My pleasure Supermanny, hope it helps you out. Its pretty easy if you just follow the steps I wrote.

good luck

 

Hey guys, its nelson4141 down in MIA. My top is not opening properly. The rear lid does not go up all the way and i have to help it a little so the other section can come down. Any suggestions? I topped off the fluid and adjusted the switch. Didnt work.Thanks in advance

 

It sounds like it moves then stops. If the switches are working & adjusted and the fluid is correct I would go with a weak pump. BUT, I would go seek qualified help because you just exceeded my knowledge of the system.