Dino Pull Removal Help | FerrariChat

Dino Pull Removal Help

Discussion in '206/246' started by Exact10, Mar 25, 2010.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. Exact10

    Exact10 Karting
    BANNED

    Mar 11, 2007
    67
    Pleasanton, CA
    Full Name:
    Annie's Daddy
    I am trying to remove the two handles on my L series that release the gas filler flap and the middle trunk, I've taken out the screws and loosened off the cables, they are stuck and it seems that they are caught behind the rear panel. Anybody know what I'm doing wrong?
    Thanks
    Ian
     
  2. daviekj

    daviekj Formula Junior
    Silver Subscribed

    May 9, 2008
    486
    UK
    #2 daviekj, Mar 25, 2010
    Last edited by a moderator: Sep 7, 2017
    Ian, I think you need to detach the wire ends to the fuel cap, engine lid and boot before being able to pull the plastic moulding and chrome levers in towards the cabin to work on them or replace them. I have only removed the moulding with the fuel tank out. The attached photo shows the back of the moulding when viewed after fuel tank removed. the two moulding screws can be seen. You need slack in the wires to pull the moulding out of its socket. One of those tasks that looks simple, but turns out to be quite involved. Others may have a work around.......
    Kevin
    Image Unavailable, Please Login
     

Share This Page