3m Clear Bra on 2002 360 Ferrari | FerrariChat

3m Clear Bra on 2002 360 Ferrari

Discussion in 'Detailing & Showroom' started by NeilA, Nov 14, 2011.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. NeilA

    NeilA Rookie

    Joined:
    Nov 3, 2011
    Messages:
    10
    Location:
    Louisiana
    Full Name:
    Neil
    I have a small area (about the size of a quarter) in the bottom edge of my 3m clear bra that is not stuck to the car anymore. It is in the front side of the front tire area on the fender near the ground. It is quite gunky, but I am sure i can clean it. Any advice on how to get this to re-stick and any advice on cleaning the area first?
     
    NeilA, Nov 14, 2011
    #1
  2. HTP AutoWorks

    HTP AutoWorks Rookie

    Joined:
    Sep 19, 2008
    Messages:
    30
    Once it has lifted and has dirt under it, the film can not be cleaned and layed back down. Unfortunately it will have to be replaced.
     
    HTP AutoWorks, Nov 14, 2011
    #2
  3. 1slocrx

    1slocrx Karting

    Joined:
    Jun 26, 2011
    Messages:
    54
    Location:
    Bay Area, CA
    Careful upon removal...if there are any big rock chips that may have gone through the film, when you remove the film the paint will peel off with the film. I had this happen to my 360. Front bumper looks pretty bad now.
     
    1slocrx, Dec 3, 2011
    #3
  4. HTP AutoWorks

    HTP AutoWorks Rookie

    Joined:
    Sep 19, 2008
    Messages:
    30
    Sorry, it will not typically peel off with the film. The only time that will happen is if the film was aplied to fresh paint that has not fully cured. I have removed film off of dozens cars without ever having a paint lifting issue.
     
    HTP AutoWorks, Dec 3, 2011
    #4

Share This Page