Stabilant 22A on ABS sensors?? | FerrariChat
Buy

Stabilant 22A on ABS sensors??

Discussion in 'Technical Q&A' started by bikz, May 9, 2013.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. bikz

    bikz Formula 3

    Mar 2, 2012
    1,043
    Malaysia
    #1 bikz, May 9, 2013
    Would it be okay to apply some Stabilant 22A on my 348 ABS sensors directly which are plugged on the brake calipers? The sensors which face the brake disk -the ventilated bit of the disk. Thanks
     
  2. andyww

    andyww F1 Rookie

    Feb 7, 2011
    2,775
    London
    #2 andyww, May 9, 2013
    Those are the brake pad wear sensors not ABS. Probably wouldnt do any harm, or any good for that matter.
     
  3. bikz

    bikz Formula 3

    Mar 2, 2012
    1,043
    Malaysia
    #3 bikz, May 9, 2013
    sorry i'v been at it for way too many hours i'm getting stuff mixed up....i meant at the back of the hub.....it is the ABS sensors....wait i'll try to see if i can get any photo of it "borrowed" from another thread.....
     
  4. bikz

    bikz Formula 3

    Mar 2, 2012
    1,043
    Malaysia
    #4 bikz, May 9, 2013
    Last edited by a moderator: Sep 7, 2017
  5. 2NA

    2NA F1 World Champ
    Consultant Owner Professional Ferrari Technician

    Dec 29, 2006
    18,221
    Twin Cities
    Full Name:
    Tim Keseluk
    #5 2NA, May 9, 2013
    No reason to put anything there. There is no electrical connection. Make sure everything is clean.
     
  6. andyww

    andyww F1 Rookie

    Feb 7, 2011
    2,775
    London
    #6 andyww, May 10, 2013
    +1

    Dont remove them. There are very thin shims which control the spacing between the sensor and toothed wheel and if you lose any or the spacing changes because of dirt etc, the ABS will no longer work properly.
     

Share This Page