Spider hoop windscreen R/R

Does any one know how to R/R the hoop windscreen on a spider? Mine is torn and need replacement.

 

You can partially open the top and remove two bolt holding the windscreen on

 

Thanks! I'll give that a try.

 

Mine aren't torn but they keep coming out. I am thinking I may try to put molding adhesive at the very bottom of the groove and on the bottom edge of the screen. Then again, I am open to other suggestions.

 

I just worked on it the past few hours. The rubber seal surround is glued in place with something like rubber cement. If the rubber seal is pliable, you can pry it out of the channel and re-glue it. If it is semi-hard, then I wouldn't mess with it because it'll break into pieces when you try to remove it.

 

How did you remove the windscreen? Did you use a heatgun? Pics will be helpful if you took them

Mine is scratched, and a bit faded but I'm not touching it if its a big job.

 

How did you remove the windscreen? Did you use a heatgun? Pics will be helpful if you took them

Mine is scratched, and a bit faded but I'm not touching it if its a big job.

 

Any photo's of it please ?

 

How 'bout a trade? Answer this question and I'll do a DIY.

I notice that when I drop the top, the side of the canvas touches the body frame. Is this the same on your spider? A yes or no answer is fine. See pictures.

Also, here's an AFTER picture of the re-screening of the hoops.
Image Unavailable, Please Login
Image Unavailable, Please Login
Image Unavailable, Please Login