Hi guys, Will it be too low with this H&R springs ? H&R Ferrari F355 F129AB 05/94 03/99 30/20mm Lowering Springs | eBay As I understand -30mm on front and -20mm on rear? Want to have a look like on photos (how much you think on this photos it lowered in front and rear?) http://www.lookautophoto.com/images/tuning-ferrari-f-355-01.jpg http://www.m5board.com/vbulletin/attachments/e39-m5-e52-z8-discussion/412682d1398877413t-m5-has-stable-mate-ferrari-8648289317_c6bce99c0b_o.jpg Thanks
you can get the ride height you are looking for in those pictures.. by adjusting the collars down on the stock suspension.. you dont need the springs.. however the H&R springs are shorter.. so you can have a drop to the car, without adjusting the collars on the coilovers.. the yellow 355 in the second pick is dropped with stock suspension only.. no springs.. however keep in mind. both those cars have 19" rims on.. so they fill in the wheel gap more.. to get a flush look with the stock 18" rims on.. the car would almost be on the floor..
Ive got h&r on my car with the collars lowered as well, car is very low, almost too low. The middle of the car scrapes on occasion if I'm not careful.
Low is good check out these specs OEM Challenge springs. nice and low 2- 800lb 6.5" length 2-850lb 6.25" length 2-275lb 4.0" length Image Unavailable, Please Login
If you want to go this low you´ll need the H&R springs. rear you can get down without . not the front. Garaget | Ferrari F355 GTB (1996)
I've got H&R on mine (see pics in profile). Front is set with collar all the way up, rear is set to match (around half way).
The car at factory ride height only has 4.2" of ground clearance and you want to set it down to 2.9" ? Where do you find the billiard table smooth roads to drive?
+1. I had the stock suspension, but the front springs took a set, and I was sitting +2cm low in front...the front bumper skid plates I installed took a beating, as did the center diffuser under the car. I got everything repaired, and had the front raised back to stock height, right out of the owners manual...never scrapped again....but it did look like it was riding high.
Mines lowered on stock springs and I've never scrapped anywhere, never plan on it. It does mean i have to avoid certain businesses and gas stations however. Even a lowered 355 is still higher then my stock z06 was.
Still hanging around the F355 forum Fred? I've got your skid plates in my living room (will fit them eventually) and they are untouched!
