Radiator tank mounting crossbar

Looking for the crossbar the radiator tank mounts to. The one I have has the number from a rare Dino that is being restored and should be re-united with it but that leaves me needing one.

 

superformance do good reproduction ones

 

I have a related question. On my car the expansion tank has a small braided hose going forward from the end of the tank. I can't get it loose to repair the tank without destroying it, (or shortening it too much). Does someone have a direct replacement or what is the size of the hose?

 

I am certain we can make one...

Please write: alberto.guirola at gmail.com

Regards, Alberto

 

Tony, cannot find it.

Regards, Alberto

 

The fellow with the rare Dino has offered to make me a new one but I thought someone might have a spare they could let go.

 

It should be reinforced rubber (same as the heater) hose and is used to provide vacuum relief. Not sure on the size. Try to slide a small screwdriver under the hose, they get very hot and trend to weld themselves to the metal............

 

Alberto

I take it this is the part

101497 £3.98 each

Cooling System Parts for Ferrari 206 & 246 - Superformance

Regards

Tony

 

Wrong part Tony, it is the long 30mm pipe, threaded at the ends and with the expansion tank mounted to it.

We already made one I was missing.

Regards, Alberto

 

Spares ought to be rare, and I don't have a spare, but can zip one up for you.
I have the original to copy from, and I am certain, will be less expensive. Are you in extreme urgency?

Regards, Alberto

 

Alberto, Thanks for the offer but part of the deal is making me the bar. I thought if I could find an original would be best for me if possible. It is a fairly simple part to make.

 

Sorry Alberto I didn't read the original post correctly, I now know the part you are referring to. Simple to remake I would have thought.
Tony

 

You are welcome, it is easy to make, but finicky to make look proper.

Regards, Alberto

 

Tony,

Thanks for the input. I tried to loosen it with a screwdriver, just couldn't get under it enough. I guess I'll just use plain cooling system hose until I can find appropriate, cloth braided hose.

Thanks again...

 

It happens Ken, if there is no slack in the hose then its best to renew, if you do get the old hose off then it may not reseal when you refit it.

If you have some slack then just put a small slit in the hose with a utility knife and cut back the hose by an inch.

tony