Countach Lig Nuts

Hi guys perhaps someone can help, I am trying to source the correct lugnuts for my OEM Countach wheels the hole in the wheel appears to be 14mm
The holes in the wheels are slighty larger than a set of Volvo bolts i have also sourced they measure 13.7mm shank x 57 long with a 18.7mm head the Volvo bolts are a very snug fit into the wheels the Volvo bolts taper appears to be a good match to the marks left by the previous owner, and the bolt head seems the same size where it fits against the rim, i really want to get these correct can anyone confirm the shank size, length and pitch for me as i really want to get this correct, i remember one of the forums from about 8 years ago had a post on it but i have had no luck finding it, any help much appreciated.
Best Regards
Graeme

Image Unavailable, Please Login

 

Same as a BMW (e34, e36, e46, e39, e9x, e60 etc)

The lengths are different (shorter on BMW) but you can buy extended ones for the rear of the Countach (or BMW) if you had to.

 

S Agata, thanks for the quick reply i also got some E39 from the pickapart, but they were only 11.7 shanks and i worried they may be a bit small sadly my car is a replica using e39 alloy uprights and they have 11.7 holes so i was thinking of having them bored out to 13.7 but that dont leave much room for error when its going in a 14mm hole. I also have a BMW 750 and noticed they are 11.7 also its an E38 Image Unavailable, Please Login

 

Never considered the shank, good to know.

 

I believe same as fiat x19 parts

 

I got a new set for my car about a year ago. I won’t be near my notes for another week though. I can get back to you then if you are still looking

 

Thanks Blown that will be great it seems there is limited info out there as to what lambo used