348 TS Badge?

the way its fastened, its not removable from the door without damage. Just swapped mine because the plastic door it attaches to would no longer stay up. the used part I had purchased was off of a spyder, so I had though about swapping the badges, but ended up needing to swap the whole outer door assembly.

 

Surely it's just a case of removing the 4 screws that hold the plastic inner plate to the outer door (No.46 below), separate the inner and outer parts of the door, undo the two clips that are fitted to the badges pins(No. 44 below), and then remove the badge?
Image Unavailable, Please Login

 

the little pins on the two in my possession would be destroyed trying to remove them. Now if you did not car about the door itself, or the retainers, it might be possible to cut them to get the emblem off, but it would take some finesse.

they are small star-lock retainers.
Image Unavailable, Please Login

 

Those can typically be finessed off the studs without destroying anything but they usually need to be replaced afterward.

 

Try Eurospares

Search Results for 62990000 - Eurospares | Order Online Eurospares

And, Try Algar Ferrari - speak with Livio

 

"NEW To Order Subject to Availability" on Eurospares means that they have none in stock and don't know when they will have any ever again.

The only badge they have in stock is for the 348 Spider.

The badge in question is a USA market item that is not going to be a big money earner for them due to the limited demand, so I doubt that they'll have them in stock again anytime soon.

 

Not exactly. Yes, it means they have none in stock - that is correct. But, it does not mean they can't get it.

I've bought many parts from them that they did not have in stock and had to order. It usually takes 1-2 weeks for them to get it.

I'm not suggesting in this case the part is available but without reaching out to them and asking, one will never know

 

i know this is an old thread, anybody with a good ts badge thought about doing a clay imprint? If I had a good imprint I could use it as a mold and make replicas

 

They sell replica badge keychains on eBay for $10.

I got one as a gift a while back and threw it in a drawer. I seem to remember it was pretty dang close. I’ll dig it out and post a comparison here.

 

Try here: Ferrari 348ts Badge

 

thanks for the link!

 

I had one until some weeks ago from a 348 TS that I demolished, will have one again in a couple of weeks. Send me a PM for availability

 

Wow and you didn’t save it before it was crushed? Maaaan

 

Yes, I did, but it was instantly sold

 

ahhh, cool. Makes sense.