246 Dino Cooling Fan | FerrariChat

246 Dino Cooling Fan

Discussion in 'Technical Q&A' started by boboding, May 4, 2022.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. boboding

    boboding Rookie

    Joined:
    Oct 8, 2009
    Messages:
    15
    Location:
    Upstate NY
    Full Name:
    Bob Fennell
    Can someone tell me what type of screw holds the fan onto the shaft of the motor? The one you get to through the access hole. I can’t get a hex drive or anything else to get a purchase on it and can’t get the fan and motor out as a unit. AC car….
    Thanks as always!
    Bob.
     
    boboding, May 4, 2022
    #1
  2. TTR

    TTR F1 Veteran Rossa Subscribed

    Joined:
    Mar 29, 2007
    Messages:
    5,922
    Location:
    Riverside, CA
    Full Name:
    Timo
    You might have better chance for answers, right or wrong (depending on how clearly you describe the issue), if you post this in the “206/246” forum section, but based on my experiences with Daytonas, I would think the set screw in this case (holding the fan hub to motor shaft), if not hex head, could also have a single blade screwdriver slot.
     
    TTR, May 9, 2022
    #2

Share This Page