F12 Operating Temperatures

Seems high for city driving. I am assuming you are keeping it around 4k rpm? I am usually at 180 driving regular but will see higher temps like you have here when getting on it. I find my temps only increase when I sustain higher than 4k rpms for longer periods of time.

 

I see the same. 185 in FL during the summer.

 

What I say..unless you didn't notice before always go back to what changes were made .. in this case coolant change .. could it be air pockets .. was anything else changed.. different grade oil etc

Sometimes i have seen the opposite..cooler running engines after a change ..most likely the amount was low before change

Just throwing out some ideas ..


Check oil.level as well

Sent from my moto g power using Tapatalk

 

The only time my temps go up to 205 or thereabout is when I’m idling sitting at a light for a few minutes. Once I get going the temp drops to around 175 - 180 regardless of ambient temperature.

I just had my annual service done and they changed the coolant on mine and the temps are the same as they were before the service. They did however find a small crack on the thermostat housing which caused a slight leak of coolant and they told me it would get worse if I didn’t change it and it could cause overheating so naturally I did. They said it’s not a common issue they see but I have a 2014 model so it wasn’t unheard of for it to need replacing. They didn’t have the part of course and they had to order it and it took 6 weeks to get.


Sent from my iPhone using FerrariChat.com mobile app

 

Your temps are high compared to my norms, and I’m in the Houston area with higher ambient temperatures.

 

185 to 190 water temp, 180-190 oil.

 

You have to hand it to Ferrari to go out of their way to design digital versions of analog gauges and yet make it impossible to read them (8.75 degrees per mark water temp!!)

My F12 water temp will always be the lowest value when speed is high. Never owned a car that was this tied to air flow. Almost like an air cooled engine. Oil temp is way more important though and that stays pretty constant.

 

Could also be coolant/water ratio. A 60/40 mix for example will do a worse job removing heat than a 50/50 Mix. Any idea what they put in?


Sent from my iPhone using Tapatalk

 

I will point out again that its not clear to me how one can read those gauges accurately; however, what you are describing here is how I would describe mine at that ambient. Perfectly normal. If you want to try something then use Water-Wetter or equivalent. This is a coolant additive that breaks the surface tension of the metal-to-water contact areas allowing better contact and heat flow between coolant and metal.

I use this in my race bikes and it noticeably reduces temps on hot days delaying or avoiding coolant spill-over. Its bright/florescent orange and you only add a little. Safe for most metals. Also, make sure you use distilled water and fresh antifreeze but I use less antifreeze than stated amounts and add some water pump conditioner that looks a little bit milky white.

Image Unavailable, Please Login

 

A thermostat struggling to adjust to ambient temps shouldn't matter once the car reaches operating temp. At operating temperature the thermostat should be open-loop and essentially no longer part of the equation. A sticky or malfunctioning thermostat will also usually throw a code, at least a soft code. I'm a believer in the Water Wetter Solid State posted but I don't believe it'll be enough to correct an actual issue. There may be some air in the system, which should self bleed eventually. I don't know off the top of my head if F12's can be manually bled but can check the service manual this weekend.