360 - DIY clutch service on f1 360 | FerrariChat

360 DIY clutch service on f1 360

Discussion in '360/430' started by Bowes, Jun 20, 2022.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. Bowes

    Bowes Rookie

    Joined:
    Feb 20, 2017
    Messages:
    18
    Location:
    South africa
    Full Name:
    Richard
    I’m about to tackle a service on my clutch and throwout bearing on my f1 360 . I’m also upgrading the TCU to challenge stradale . Anyone embarked on such a diy job ? I have a fairly good WSM but any tips would be appreciated.


    Sent from my iPhone using FerrariChat
     
    Bowes, Jun 20, 2022
    #1
  2. tomw

    tomw Formula 3 Silver Subscribed

    Joined:
    Feb 25, 2004
    Messages:
    2,413
    Location:
    London
    Full Name:
    Tom
    ratarossa has a good video on doing a clutch and bearing.

     
    tomw, Jun 21, 2022
    #2
  3. Bowes

    Bowes Rookie

    Joined:
    Feb 20, 2017
    Messages:
    18
    Location:
    South africa
    Full Name:
    Richard
    Thanks Tomw very interesting. The mechanical side doesn’t bother me at all , it’s really the electronics . I have purchased a launch x431 and hope that will deal with all the electronic issues such as bleed and clutch setup .


    Sent from my iPhone using FerrariChat
     
    Bowes, Jun 21, 2022
    #3
  4. flash32

    flash32 F1 Veteran

    Joined:
    Aug 22, 2008
    Messages:
    6,900
    Location:
    Central NJ
    Full Name:
    Dominick
    If you have the CS TCU and a launch you will be fine

    Sent from my moto g power using Tapatalk
     
    flash32, Jun 21, 2022
    #4
  5. 67bmer

    67bmer F1 Rookie Silver Subscribed

    Joined:
    Oct 28, 2015
    Messages:
    2,959
    Location:
    MD
    a few cringe-worthy moments, but it goes to show you they are relatively easy cars to work on if you take your time and are careful!
     
    67bmer, Jun 21, 2022
    #5

Share This Page