I will change my tunnel by carbon one. For beguining I know how remove all the plate and buttons on tunnel but after ? How we do? Are they some screws ? Must be careful to something ? Is there a technical thing? All helps will be appreciated. Pictures could be shared. Thanks a lot
First, remove the four screws at the back side of the tunnel and lift out the back trim piece. This will allow you to remove the center tray, which is held in by a single nut on a stud. There are four screws holding the tunnel cover in place. Two front, two rear, then lift out. Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login
Thank you very much my friend, because of you, all will be more easy for removing ! I understood all with your explain and pictures Very great
Your illustration is fabulous, I will add 2 screws in front I had on mine, I think all we have, on this side ( arrow) and in the other side Image Unavailable, Please Login
Well done thanks Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login
Yes i took pictures lol Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login
The wiring diagrams will tell you which plugs go where (based on wire colour). Don't panic if you forget which is which. When you put the car back together, can you confirm that the white plug locks the doors please? Image Unavailable, Please Login My switches seem reversed. I think my "lock" is red.
Thanks. I'm confused... Which button do you consider to be "unlock"? This one? (A) Image Unavailable, Please Login or this one? (B) Image Unavailable, Please Login The manual shows this, but doesn't show the symbols: Image Unavailable, Please Login Various online photos show the switches in different positions
There are many photos online showing different locations. Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login I assumed the symbol with the key on it was LOCK. My key symbol switch has a red plug.
Hey guys. I don’t have a GTS, so I’m curious. Why does the leather console have 4 screws in the rear to remove a panel, but a carbon version doesn’t? Image Unavailable, Please Login
Because the screws are there to secure a leather covered panel that the carbon version does away with.
To hold down the aluminum covered in leather that has a lip that’s secured by the covering missing on your carbon item. Looks like to fit the carbon item you would have to have a custom leather cover made. Image Unavailable, Please Login Image Unavailable, Please Login
Aha! Dammit. More things I need to figure out. @C'dwic Is the Spider leather-covered aluminum different than the GTS'?
The panel which is showed by Elliot seems to be different between GTS, spider, and berlinetta Image Unavailable, Please Login
On Green, you see difference. Size is changing, and on Spider you must integrate the Switchs you don't have on GTS and berlinetta. I tryed yesterday, i will take picture today but it will be possible to install my plate on carbon tunnel without modification. Perhaps i will need some 3M as scratch for the rear but i can screw the plate on front
No need 3M Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login
