How to clone a black remote fob ....

Here is a youtube video with everything that you need to know about the key fob remotes for these Ferrari models

https://youtu.be/a8vGE_k8BKk

 

This explains the problem with cloned fobs

https://www.youtube.com/watch?v=GRBLs2_Ab-w

 

Hi Everyone. I have been a member for a few months since I got my 2003 360 spider. I am trying to get in touch with "Gobble" but I do not have sufficient privileges to PM. I was given his name by the Service mgr at Ferrari of New England, where I purchased the vehicle from, for some key fobs replacements. Can anyone help me here ?
Thanks in advance ! Mike in Fl.

 

This is Mark's email:

[email protected]

 

Me, too. I did not receive the code with the car when purchased (thanks to a crappy PPI that missed that it was missing!) although I have all three FOBs. I had been resisting sending my Red FOB to ImmoFixer in Australia for a long time due to both cost and risk. I recently found that Jorge at ECU Doctors can now read the code from either an immobilizer or a Red FOB. Jorge was fast and reasonable! I have since found that Gobble can also do it. Good news for those in the US!

 

Jorge at ECU Doctors can help with this...

 

I should also mention that ECU Doctors now offers a full set of new FOBs that feature a new PCB design and use a common, long lasting coin cell. They also have new high quality cases. Both Red and Black I believe...

 

Hi, I am newbie Ferrari owner who just purchased a 550 Maranello in Hong Kong with only one black key fob. I have seen that Gobbler and Eric355 can clone the black fob. I can't PM them because I am not approved yet. Not sure if Gobbler can do this because my fob should be on European frequency or only Eric355. Would appreciate if someone can put me in the right direction on how to contact the correct person if I can't PM them. Also, am I suppose to provide the new fob for them or do they provide that too (from the forums it seems a Porsche 993 fob works too if I can't find a Ferrari one, also saw Ford fobs which is strange)? Really excited to join this community. Thanks!

 

You can shoot me an email [email protected]


Sent from my iPhone using FerrariChat.com mobile app

 

Hi Eric,

I know this thread is a little old. Are you still cloning fobs?

Thanks in advance!

 

Mitch- Instead of cloning your fob, how about having him build you a new set of three fobs with a new PIN?

 

Stop talking dirty! That does sound much better. I'll drop him a line

 

Bonjour @eric355, je suis possesseur d'une F355 depuis 2 ans et j'ai plus que la télécommande rouge en état de marche (j'ai 2 télécommandes noires mais non -actives) ... mon code PIN n'est plus lisible et lorsque l'on le demande à Ferrari, il n'est pas bon. La seule solution qu'ils me proposent c'est de remplacer tout le boitier alarme pour 2500€.
J'ai cru comprendre que tu avais une solution !!
Etant de Montpellier j'aimerai savoir s'il y a une possibilité pour que je vienne à Toulouse pour voir si tu peux faire quelque chose ?
Merci de ta réponse
Séb

 

Benoit, I am sure Eric can do something....

 

Bonjour @sebbenoit , je crois que tu auras plus de chance de le contacter via le forum français ou il est plus souvent présent

 

Hi @eric355 ,
I'm desperately looking for the dump of a red and a black remote. Since I have virgin remotes of FORD RK112 which are the same ones used by Ferrari, I wanted to convert one making it master. By comparing the dumps we have, perhaps we can figure it out. Could you help me by sending me the dumps?

 

Several folks can now set you up with a fob set or reprogram yours and pull your PIN from your red fob or immobilizer, including Eric.

 

@tazandjan @gobb @eric355 OK perfect. I have 3 slave fobs (black). 1 running and 2 new ford precoded. Reading dump of the bosch immo I would like to convert the two ford remote controls into master and slave so as to have a complete set of remote controls: 1 red and 2 slaves with pins. Anyone who can help me please contact me on my email:
[email protected]
Thank you

 

PM sent, Michele.