456m bellhousing timing mark question

Have a picture? I am unaware of any flywheel timing mark.

I just thumbed through the manual and see no mention of a flywheel timing mark.

 

Have a picture? Factory says nothing about them.

 

Somebody put a Daytona engine in a 456M?

 

Daytona timing marks were on the bottom.

I was just looking at pictures of 456 blocks. There is no hole I can see in the top rear of the block or the bell housing.

There are holes about 30 degrees from the top in the bell housing but those are not for timing.

 

Brian is correct..there are no marks on the flywheel. To find TDC use a dial indicator or piston stop.

 

Brian- Yup, spent a bit of time lying under mine while the wife ran her up to 5000rpm.

 

Takes a little getting used to.

 

Affirmative, a bit noisy down there with things going round really quickly. Too old (lazy?) for that now. Plus, my Daytona was $5000 and a $10,600 Dino. A bit more now.