Minimum recommended climate conditions for garage | FerrariChat
Buy

Minimum recommended climate conditions for garage

Discussion in 'Texas' started by HoustonNoProblem, Jun 8, 2024.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

  1. HoustonNoProblem

    HoustonNoProblem Rookie

    Mar 16, 2024
    31
    #1 HoustonNoProblem, Jun 8, 2024
    I have been reading various forums trying to understand how to preserve the car in TX (especially as they age and considering what climate can do to rubber, paint, and perhaps more specifically for Ferrari- leather dash) in the most sensible way possible.

    Some say heat is the culprit, others humidity (still others cold, but that isn’t relevant for most Texans).

    Is there consensus on what it is, or both? And whatever it is, is there consensus on minimal recommended temp/humidity?

    So for hot and humid climates like Houston (or even parts of Fl for that matter), what is recommended?

    Some ideas I have read:

    Insulated garage (done)
    Desiccant packs inside car?
    Garage roof vents?
    Car cocoons, which?

    I do not want to run AC or dehumidifier for the entire garage because I think during TX summers those would be running almost all day to keep up. The initial and ongoing cost would be like buying an insurance policy for a relatively non major repair (dash, buttons, belts, hoses) for something that might occur x years down the line.
     
  2. Texas Forever

    Texas Forever Eight Time F1 World Champ
    Rossa Subscribed

    Apr 28, 2003
    85,557
    Texas!
    #2 Texas Forever, Jun 8, 2024
    Number one culprit is not fully drying a car after washing. This applies everywhere.

    In Houston, humidity is the big problem. Best bet is to run an A/C at 78 or so and a dehumidifier.
     
    WJHMH and HoustonNoProblem like this.
  3. Texas Forever

    Texas Forever Eight Time F1 World Champ
    Rossa Subscribed

    Apr 28, 2003
    85,557
    Texas!
    #3 Texas Forever, Jun 10, 2024
    BTW, I'm not sure sticky buttons are related to heat and humidity. From what I know, it is the oil and whatnot on your fingers, but I could be wrong.
     
  4. JSwan724

    JSwan724 Karting

    Jun 1, 2023
    65
    #4 JSwan724, Jun 10, 2024
    Agreed with the A/C and heat option.

    I have a 2 ton split on the wall that will maintain a steady temperature winter or summer.

    The new ones don’t draw that much electricity. and the FEDS and your Texas utility in your case may give you a rebate because it’s energy efficient.
     
  5. A12pilot

    A12pilot Formula Junior
    Rossa Subscribed

    Aug 11, 2018
    529
    DFW
    Full Name:
    Dave
    #5 A12pilot, Jun 22, 2024
    Ditto. I have a 3-ton mini-split in my shop. Love that thing. Can't imagine life without it! Even a smaller one that runs on 115v is very efficient. I'd get a quote for one of those. They require next to no maintenance other than cleaning the exterior coil (free from debris) and inside filters.

    Cheer
    Dave
     
  6. kestrou

    kestrou Formula 3
    Rossa Subscribed

    Jan 22, 2023
    1,432
    Danville, IL
    Full Name:
    Kevin E. Stroud
    #6 kestrou, Jun 22, 2024
    I don’t recall the tonnage of my mini-split - but it’s AWESOME - get on board! :)

    Kevin
     
  7. one4torque

    one4torque F1 Veteran
    Silver Subscribed

    May 20, 2018
    5,585
    Houston
    Full Name:
    One4torque
    #7 one4torque, Jun 23, 2024
    Tx mini split people— did you notice an elec bill bump
    Keeping a shop at 78-ish f in the summer?

    I currently use mine for days I work in the shop., but leave off ..



    re sticky buttons and dash shrink-
    My exp is that my 01 360 was sticky free and dash shrink free until I left my car for service at a shop that left if in the Texas sun for 3 weeks in the summer…. While the orig bits were old., they melted after this episode. Just something to keep in mind.

    I think the treatment becomes unstable.. and the heat radiation finished it off. Fyi.
     

Share This Page