Mondial Exhaust Help/Question | FerrariChat

Mondial Exhaust Help/Question

Discussion in 'Mondial' started by Caz-Man, Dec 24, 2024.

This site may earn a commission from merchant affiliate links, including eBay, Amazon, Skimlinks, and others.

Tags:
  1. Caz-Man

    Caz-Man Rookie

    Joined:
    Nov 6, 2024
    Messages:
    1
    Full Name:
    Tom Kubiniec
    1987 Mondial (US Spec Car)

    I have just upgraded the muffler to the Quick Silver unit. I have retained the OEM CAT (It has been hollowed)
    When I removed the stock muffler, I did not see the O2 wires and they pulled from the harness. I have the new system in place but I cannot find where the Sensor and other wire plug in.

    Where is that Harness connection point?

    Any help is appreciated.

    Image Unavailable, Please Login

    Image Unavailable, Please Login

    [​IMG]
    [​IMG]
     
  2. Alden

    Alden F1 Rookie Rossa Subscribed

    Joined:
    Apr 25, 2010
    Messages:
    3,604
    Location:
    Central Florida

    Attached Files:

  3. theunissenguido

    theunissenguido F1 Rookie Owner Silver Subscribed

    Joined:
    Jan 21, 2004
    Messages:
    2,668
    Location:
    Argent/Brasil
    Full Name:
    Guido
    A 328 US has this connection under the fuel distributor on the right side of the engine. I think for a mondial US should be the same place.
     
  4. Alden

    Alden F1 Rookie Rossa Subscribed

    Joined:
    Apr 25, 2010
    Messages:
    3,604
    Location:
    Central Florida

    Attached Files:

  5. Steve Magnusson

    Steve Magnusson Two Time F1 World Champ Lifetime Rossa

    Joined:
    Jan 11, 2001
    Messages:
    26,794
    Location:
    30°30'40" N 97°35'41" W (Texas)
    Full Name:
    Steve Magnusson
    No, those are the Frequency Valve connector (whitish/yellowish) and the Safety Switch connector (greenish/bluish). The O2 wiring will be coming off the assembly with the Protection Relay -- item 19 here in the right rear trunk area (on the bottom of the panel):

    https://www.ferrariparts.co.uk/Diagram/Ferrari/32-Mondial---Cabriolet/127-Secondary-Electrical-Boards-Ch88-Excluded

    and they will be routed sort of beside the airflow metering unit like this (but this photo is a little mislabled as the green wire with the male spade and beige end is actually the input wire to the Lambda ECU and is where the single wire with the female spade from the O2 sensor would be connected):

    Image Unavailable, Please Login
     
    Last edited: Dec 25, 2024
    Alden likes this.

Share This Page