Pic of your 360 or 430 you took today or recently

Nice car mate. I recommend not using the AC on full fan yet! Pull each air vent one by one (they just pop out) and remove all the dead foam and then remove the black greasy stuff with a damp microfibre.

Also pop your rear speaker grilles with a trim tool and check if the rubber in them has gone bad. Mine had disintegrated really badly. There is a sub in the bottom cut out and a passive cone in the top one.

Image Unavailable, Please Login

 

Annual Service Time...
Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login

 

You worried about keeping those exhaust brackets in place or did you already change out your headers?

 

I have the challenge headers and the exhaust brackets are the Fabspeed ones I installed before I switched to the Kline, which allow movement in the horizontal, not vertical direction, so the exhaust doesn't move up and down, only in and out. The brackets are water cut and bent so they are not spring-type of flexible, but they are more flexible than the oem brackets that try to not allow movement in any direction and crack because of it. I should also mention since I don't have pre-cats from the stock headers, the exhaust should not expand as much because the temperatures in the engine bay are much lower now.

 

Image Unavailable, Please Login

Just your average Costco run! I was most concerned about the eggs. If they broke, I may have needed to sell the car.

 

Interesting, I wouldn't have thought to check either of those things. Thanks.

 

The best was when I did a Costco run about 25 years ago and I had both the front and rear trunks open in my Boxster filled with shopping. At least 3 people came over to ask me where the engine was. These days no one would bat an eye since many electric cars have both front and rear trunks.

 

My other car is a GT4. I may have loaded the rear hatch full of lumber on more than one occasion... They're quite functional cars!

 

New floor!

Image Unavailable, Please Login

 

Congrats! That doesn't look like rosso corsa?

 

Rossa Scuderia i think Boba Fett has on his spider

 

It's rosso corsa

 

Did you know Enzo Ferrari was never happy with how Rosso Corsa looked on Camera as it was not so bright red as it looked in the metal, so he developed the colour, Rosso Scuderia because on Camera it looked like Rosso Corsa did in the metal!

Not a lot of people know that !

 

I did actually but interestingly I knew that because of Ducati, not Ferrari. It's the same thing with Ducati red.

I was on a tour in the Ducati factory in Bologna (of course I went to Ferrari that day too) and everyone was wondering why their Moto GP bikes were orange and not red. Like you said, it's because the color wouldn't show up right in pictures or on TV.

Although interestingly this is no longer the case now with HDR. Previously that shade of red was outside of the 8 bit color gamut of normal TVs but now with 10 bit color on HDR TVs they can finally show true Rosso Corsa.

I think Gran Turismo 6 or 7 was actually the first video game to have true Rosso Corsa in it because of this as well, all of the previous racing games didn't use 10 bit color.

 

Every days a school day!

 

Image Unavailable, Please Login

 

A little dash change.
Image Unavailable, Please Login

 

Love the bare metal badge. I did the same thing.
Image Unavailable, Please Login Image Unavailable, Please Login

 

Did a deep clean in my wheel wells today. It was all muddy from a very wet club drive last month. This is actually much cleaner than it was as I drove through the rain on Thursday.

Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login

 

haha, maybe Im a weirdo, but i do the same thing. Just as clean under as on top.


Image Unavailable, Please Login Image Unavailable, Please Login

 

Seen some awesome garage's here

Wanted to share a picture of mine as well

Image Unavailable, Please Login Image Unavailable, Please Login

 

Looks terrific Johan.. Moi!

 

I like that door protector on the wall. What are you using? Looks neat.

 

I was thinking the same thing. Us narrow garage guys want to know!

 

It is a DIY frame made of wood panels with foam, I "upholstered" that with a banner I got. It is one of those banners from a track event they use in a barrier.

Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login Image Unavailable, Please Login